Aye, me wench craves the sound and fury of me Cummins, but arrgh the Perkins leaves 'er cold.
Lay me alongside an board 'em in the (diesel) smoke... Martin ________________________________ From: cnc-list-boun...@cnc-list.com [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Dennis C. Sent: Wednesday, September 19, 2012 5:47 PM To: cnc-list@cnc-list.com Subject: Re: Stus-List Yanmar question Probably sounds more like a 1998 Honda Civic with a varoom varoom exhaust and a loud stereo. :) Arrrrrrgh!! And so ends National Talk Like A Pirate Day, September 19. Dennis C. Touche' 35-1 #83 Mandeville, LA ________________________________ From: Rich Knowles <r...@sailpower.ca> To: "cnc-list@cnc-list.com" <cnc-list@cnc-list.com> Sent: Wednesday, September 19, 2012 6:22 PM Subject: Re: Stus-List Yanmar question Jake, does it have that GMC diesel sound? Rich Knowles Indigo. LF38 Halifax On 2012-09-19, at 19:32, "Jake Brodersen" <captain_j...@cox.net<mailto:captain_j...@cox.net>> wrote: Jim, I went with a very small Vernalift muffler. It is fiberglass and should last the life of the boat. It is quiet, but has a nice warm note to it as well. It's a mellow sound that is pleasing to my ear. I've run my engine without the muffler attached. It may smoke a little bit, but what's worse is the salt spray that it throws everywhere. I don't recommend it. Jake Jake Brodersen C&C 35 Mk-III "Midnight Mistress Hampton VA From: cnc-list-boun...@cnc-list.com<mailto:cnc-list-boun...@cnc-list.com> [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of jim aridas Sent: Wednesday, September 19, 2012 9:08 AM To: cnc-list Subject: Re: Stus-List Yanmar question Follow up to my loud hissing sounding exhaust. Raw water system good, flow at end of heat exchanger going into the mixing elbow strong. Looked inside of mixing elbow, no blockage(aided by flexible fiber optic scope). I didn't want to run the engine with exhaust hose off of the elbow. figured it would make a sooty kind of mess in the engine compartment. So I've decided the lift muffler must be the culprit. Outside jacket showing some spots that look like its rusting thru from the inside out. Perhaps inside baffling is deteriorating and causing blockage? In any event looks like a potential fill the boat with water issue. As I stated earlier the engine runs ok, no overheat condition, didn't really notice lack of power. Any other thoughts? Looks like Defender has some good prices on veralift units. They also have a Vetus model twice the price looks like its a composite material. Listers any experience with either? Thanks as always. Jim Galaxy 34' Brielle NJ _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com> _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com<http://www.cncphotoalbum.com/> CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com>
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
