HI Bill
I don't have pics, can try to remember but I even forget to take
pictures of my kid so... :-)
Great that the bolt is still there. On mine the hardware is:
bolt threads into the bottom of a turnbuckle barrel, on the top of the
turnbuckle is the short section of rod. At the top on mine the rod goes
through an aluminum plate, the rod has a head formed that keeps it on
the plate, and the aluminum plate is a backing plate for the track mount.
--
Graham Collins
Secret Plans
C&C 35-III #11
Bill Striegel wrote:
Yes,the floor bolt is there. Any pics would be appreciated.
Sent from my iPad
On Aug 5, 2012, at 7:16 AM, Graham Collins<gcoll...@hfx.eastlink.ca> wrote:
HI Bill
On my boat the hardware between keel and track looks to be generic shroud
hardware, the only non standard bit is the bolt into the floor - I don't know
how that is fastened in. Hopefully you still have that bit of hardware in
place!
If you go synthetic try Colligo marine.
regards,
Graham Collins
Secret Plans
C&C 35-3
Bill Striegel wrote:
Where might I get the bolt attachments to attach the rod/high tech synthetic
to? Shroud rigging?
Tks.
Bill Striegel
1982 C&C 34
"Panacea"
Ocean Springs, MS
Sent from my iPad
On Aug 4, 2012, at 7:28 PM, "John and Maryann Read"<johnpr...@comcast.net>
wrote:
Bill
On our 34, there is a stainless rod attaching the babystay track to the
keel. It is much like your shrouds. It is located in the forward v berth
area just forward of the bulkhead for the head. The upper end is attached
to a bolt which is through the deck and track, the lower end is screwed
through the floor into the forward edge of the keel. There is a turnbuckle
for adjustment. Without this rod, the babystay tension would pull the track
out of the deck.
Hope this helps
John and Maryann
Legacy III
1982 C&C 34
Noank, CT
-----Original Message-----
From: cnc-list-boun...@cnc-list.com [mailto:cnc-list-boun...@cnc-list.com]
On Behalf Of Bill Striegel
Sent: Saturday, August 04, 2012 10:14 AM
To: cnc-list@cnc-list.com
Subject: Re: Stus-List C&C 34: baby stay deck hardware
I also cannot find the interior rod to secure the track below in the v
berth.any pics? Could lone use high tech rope? How was it attached. To the
bolts and the one on the floor? Where can one purchase the screw on
attachment points?
Sent from my iPad
On Aug 3, 2012, at 6:36 AM, Bill Striegel<wstrie...@cableone.net> wrote:
Is this correct? I need to remount it on the deck. Two block atop each
other go forward.moveable car bumper to stern. Line arrangement: tie line to
forward eye on car,then around top block,then around thimble on car,then
around lower block forward,then line to deck V-cleat? The aft thimble on
the car is not used. Correct?
Ps: anyone w picture?
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
