Bill On our 34, there is a stainless rod attaching the babystay track to the keel. It is much like your shrouds. It is located in the forward v berth area just forward of the bulkhead for the head. The upper end is attached to a bolt which is through the deck and track, the lower end is screwed through the floor into the forward edge of the keel. There is a turnbuckle for adjustment. Without this rod, the babystay tension would pull the track out of the deck.
Hope this helps John and Maryann Legacy III 1982 C&C 34 Noank, CT -----Original Message----- From: cnc-list-boun...@cnc-list.com [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Bill Striegel Sent: Saturday, August 04, 2012 10:14 AM To: cnc-list@cnc-list.com Subject: Re: Stus-List C&C 34: baby stay deck hardware I also cannot find the interior rod to secure the track below in the v berth.any pics? Could lone use high tech rope? How was it attached. To the bolts and the one on the floor? Where can one purchase the screw on attachment points? Sent from my iPad On Aug 3, 2012, at 6:36 AM, Bill Striegel <wstrie...@cableone.net> wrote: > Is this correct? I need to remount it on the deck. Two block atop each other go forward.moveable car bumper to stern. Line arrangement: tie line to forward eye on car,then around top block,then around thimble on car,then around lower block forward,then line to deck V-cleat? The aft thimble on the car is not used. Correct? > > Ps: anyone w picture? > > > Bill Striegel > Ocean Springs,MS > Sent from my iPad > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com CnC-List@cnc-list.com _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
