Hi All,
Troubleshooting part of vol3 lab3. I have checked configurations for R5
and R6 and it looks good to me but two routers cannot communicate. It
looks that the layer 2 does not work as expected.
R6#
interface Serial0/1/0
ip address 223.5.6.6 255.255.255.224
ip pim bsr-border
ip pim sparse-mode
encapsulation frame-relay
ip ospf network point-to-point
ip ospf 1 area 569
frame-relay map ip 223.5.6.5 605 broadcast
frame-relay map ip 223.5.6.6 605
no frame-relay inverse-arp
frame-relay lmi-type cisco
end
R6(config-if)#do show frame map
Serial0/1/0 (up): ip 223.5.6.6 dlci 605(0x25D,0x94D0), static,
broadcast,
CISCO, status deleted
Serial0/1/0 (up): ip 223.5.6.5 dlci 605(0x25D,0x94D0), static,
CISCO, status deleted
R5
interface Serial0/1/0
no ip address
encapsulation frame-relay
no frame-relay inverse-arp
frame-relay lmi-type cisco
interface Serial0/1/0.56 point-to-point
ip address 223.5.6.5 255.255.255.224
ip pim bsr-border
ip ospf network point-to-point
ip ospf 1 area 569
snmp trap link-status
frame-relay interface-dlci 506
R5#show frame map
Serial0/1/0.56 (down): point-to-point dlci, dlci 506(0x1FA,0x7CA0),
broadcast
status deleted
R5#
R5#
Is there anything wrong with that config?
Regards
Lukasz
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
http://onlinestudylist.com/mailman/listinfo/ccie_rs
