On 10/13/14, 9:03 AM, Jonathan Gray wrote: > The rev C I have recognises the 4GB eMMC. Does anything change if you > remove the sd card?
When I boot (5.5, snapshot, -current) from an SD card on my rev C, dmesg
always contains the following:
sdmmc1: can't enable card
I'm guessing based on previous traffic on this list that this is
referring to the 4GB eMMC. A quick glance at sys/dev/sdmmc doesn't
immediately yield the source of the error, but I'm taking a closer look now.
I'm not sure what you mean by removing the SD card--if I remove it
before booting, whatever's on the internal memory boots; if I remove it
while it's active... well, that's where BSD is installed, so I just lose
my root disk.
Here's my full dmesg (built from -current yesterday):
OpenBSD 5.6-current (GENERIC-OMAP) #1: Sun Oct 12 13:28:41 EDT 2014
r...@agawam.ednos.net:/usr/src/sys/arch/armv7/compile/GENERIC-OMAP
real mem = 536870912 (512MB)
avail mem = 518766592 (494MB)
warning: no entropy supplied by boot loader
mainbus0 at root
cpu0 at mainbus0: ARM Cortex A8 R3 rev 2 (ARMv7 core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: 32KB(64b/l,4way) I-cache, 32KB(64b/l,4way) wr-back D-cache
omap0 at mainbus0: BeagleBone
prcm0 at omap0 rev 0.2
sitaracm0 at omap0: control module, rev 1.0
intc0 at omap0 rev 5.0
edma0 at omap0 rev 0.0
dmtimer0 at omap0 rev 3.1
dmtimer1 at omap0 rev 3.1
omdog0 at omap0 rev 0.1
omgpio0 at omap0: rev 0.1
gpio0 at omgpio0: 32 pins
omgpio1 at omap0: rev 0.1
gpio1 at omgpio1: 32 pins
omgpio2 at omap0: rev 0.1
gpio2 at omgpio2: 32 pins
omgpio3 at omap0: rev 0.1
gpio3 at omgpio3: 32 pins
omap0: device tiiic unit 0 not configured
omap0: device tiiic unit 1 not configured
omap0: device tiiic unit 2 not configured
ommmc0 at omap0
sdmmc0 at ommmc0
ommmc1 at omap0
sdmmc1 at ommmc1
com0 at omap0: ti16750, 64 byte fifo
com0: console
cpsw0 at omap0: version 1.12 (0), address d0:39:72:41:e0:81
ukphy0 at cpsw0 phy 0: Generic IEEE 802.3u media interface, rev. 1: OUI
0x0001f0, model 0x000f
scsibus0 at sdmmc0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <SD/MMC, Drive #01, > SCSI2 0/direct fixed
sd0: 3781MB, 512 bytes/sector, 7744512 sectors
sdmmc1: can't enable card
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
boot device: sd0
root on sd0a (69f71c24f74bb3e5.a) swap on sd0b dump on sd0b
WARNING: / was not properly unmounted
WARNING: CHECK AND RESET THE DATE!
signature.asc
Description: OpenPGP digital signature
