>> No idea, this works fine on my BeagleBone Black (rev. A5C). >> Can you send a dmesg?
Here is dmesg as produced after booting the miniroot. I added (from memory) a message I just caught at the very start of boot: WARNING: No entropy supplied by boot loader NAND: No NAND device found!!! # dmesg OpenBSD 5.5-current (RAMDISK-OMAP) #1: Mon Jun 16 22:16:25 EDT 2014 r...@pandaes.in.nickh.org:/usr/src/sys/arch/armv7/compile/RAMDISK-OMAP real mem = 536870912 (512MB) avail mem = 515153920 (491MB) warning: no entropy supplied by boot loader mainbus0 at root cpu0 at mainbus0: ARM Cortex A8 R3 rev 2 (ARMv7 core) cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled cpu0: 32KB(64b/l,4way) I-cache, 32KB(64b/l,4way) wr-back D-cache omap0 at mainbus0: BeagleBone prcm0 at omap0 rev 0.2 sitaracm0 at omap0: control module, rev 1.0 intc0 at omap0 rev 5.0 omap0: device edma unit 0 not configured dmtimer0 at omap0 rev 3.1 dmtimer1 at omap0 rev 3.1 omdog0 at omap0 rev 0.1 omgpio0 at omap0: rev 0.1 omgpio1 at omap0: rev 0.1 omgpio2 at omap0: rev 0.1 omgpio3 at omap0: rev 0.1 omap0: device tiiic unit 0 not configured omap0: device tiiic unit 1 not configured omap0: device tiiic unit 2 not configured ommmc0 at omap0 sdmmc0 at ommmc0 ommmc1 at omap0 sdmmc1 at ommmc1 com0 at omap0: ti16750, 64 byte fifo com0: console cpsw0 at omap0: version 1.12 (0), address c8:a0:30:ad:e9:c0 ukphy0 at cpsw0 phy 0: Generic IEEE 802.3u media interface, rev. 1: OUI 0x0001f0, model 0x000f scsibus0 at sdmmc0: 2 targets, initiator 0 sd0 at scsibus0 targ 1 lun 0: <SD/MMC, Drive #01, > SCSI2 0/direct fixed sd0: 30492MB, 512 bytes/sector, 62447616 sectors sdmmc1: can't enable card boot device: sd0 root on rd0a swap on rd0b dump on rd0b WARNING: CHECK AND RESET THE DATE! # Thanks for helping me, I really would like to run my home server (nginx) and torrent client on OpenBSD! only decent alternative is Arch Linux ARM but for some reason it messes up my ISP's modem. -- Best Regards Neoklis - Ham Radio Call: 5B4AZ http://www.5b4az.org/
