I was just going to say the same thing. There is this master bypass toggle on the main unit you need to use.
On Tue, Jan 3, 2023 at 2:37 PM Nate Burke <n...@blastcomm.com> wrote: > It's not powered off, but it is in bypass. > > On January 3, 2023 1:31:09 PM CST, Daniel Pautz via AF <af@af.afmug.com> > wrote: >> >> Ahh is the whole unit powered off? Battery wise, you need atleast two >> good packs to get it going, 4x would be best (one level) >> >> >> >> *From:* AF <af-boun...@af.afmug.com> *On Behalf Of *Nate Burke >> *Sent:* Tuesday, January 03, 2023 12:28 PM >> *To:* AnimalFarm Microwave Users Group <af@af.afmug.com> >> *Subject:* Re: [AFMUG] Symmetra UPS Questions >> >> >> >> Yes, we've tried multiple combinations of pulling in/out and the silver >> on/off screw. >> >> We are wondering if its a battery problem because if we pull all battery >> packs out, it goes to 'no power modules detected'. And when we put the >> battery packs in, it detects the power modules again and its like the power >> modules try to start, but the fans cycle on and off. >> >> On January 3, 2023 1:16:31 PM CST, Daniel Pautz via AF <af@af.afmug.com> >> wrote: >> >> (dumb question but sometimes they are the easy fix) are you doing the >> little silver screw to turn them on? Also reseat them firmly then turn them >> on. >> >> We had dozens of the 80kw's running here and have been migration the to >> monster 500KW setups lately. >> >> -----Original Message----- >> From: AF <af-boun...@af.afmug.com> On Behalf Of Nate Burke >> Sent: Tuesday, January 03, 2023 12:11 PM >> To: AnimalFarm Microwave Users Group <af@af.afmug.com> >> Subject: [AFMUG] Symmetra UPS Questions >> >> I have a server room that has a Symmetra PX 20kw that I inherited. On the >> 25th it reported that 2 of the 3 10kw Power modules went bad. I ordered 2 >> new 10kw power units, and when i put them in, now all 3 power modules are >> report 'Off & OK' with a green check mark. They battery system is reporting >> 'OK' but I'm wondering if the batteries might be causing a problem. Will the >> power modules not start if the batteries are bad? There is about 9kw of >> load on the UPS. >> >> The battery system says Nominal voltage is 192v, but actual voltage is 154v. >> When we measure each pack it's at 96v. and 2x96 should be 192, so it must >> need a minimum of 2 packs to work. >> >> >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> >> -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- NOTICE OF CONFIDENTIALITY This communication, including any attachments, is intended only for the use of the addressee(s) to this email and is confidential. If you are not an intended recipient or acting on behalf of an intended recipient, any review, disclosure, conversion to hard copy, dissemination, reproduction or other use of any part of this communication is strictly prohibited. If you receive this communication in error or without authorization, please notify the originator immediately and remove it from your system.
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
