It's not powered off, but it is in bypass.
On January 3, 2023 1:31:09 PM CST, Daniel Pautz via AF <af@af.afmug.com> wrote: >Ahh is the whole unit powered off? Battery wise, you need atleast two good >packs to get it going, 4x would be best (one level) > > > >From: AF <af-boun...@af.afmug.com> On Behalf Of Nate Burke >Sent: Tuesday, January 03, 2023 12:28 PM >To: AnimalFarm Microwave Users Group <af@af.afmug.com> >Subject: Re: [AFMUG] Symmetra UPS Questions > > > >Yes, we've tried multiple combinations of pulling in/out and the silver on/off >screw. > >We are wondering if its a battery problem because if we pull all battery packs >out, it goes to 'no power modules detected'. And when we put the battery >packs in, it detects the power modules again and its like the power modules >try to start, but the fans cycle on and off. > >On January 3, 2023 1:16:31 PM CST, Daniel Pautz via AF <af@af.afmug.com ><mailto:af@af.afmug.com> > wrote: > >(dumb question but sometimes they are the easy fix) are you doing the little >silver screw to turn them on? Also reseat them firmly then turn them on. > >We had dozens of the 80kw's running here and have been migration the to >monster 500KW setups lately. > >-----Original Message----- >From: AF <af-boun...@af.afmug.com <mailto:af-boun...@af.afmug.com> > On Behalf >Of Nate Burke >Sent: Tuesday, January 03, 2023 12:11 PM >To: AnimalFarm Microwave Users Group <af@af.afmug.com <mailto:af@af.afmug.com> >> >Subject: [AFMUG] Symmetra UPS Questions > >I have a server room that has a Symmetra PX 20kw that I inherited. On the >25th it reported that 2 of the 3 10kw Power modules went bad. I ordered 2 new >10kw power units, and when i put them in, now all 3 power modules are report >'Off & OK' with a green check mark. They battery system is reporting 'OK' but >I'm wondering if the batteries might be causing a problem. Will the power >modules not start if the batteries are bad? There is about 9kw of load on the >UPS. > >The battery system says Nominal voltage is 192v, but actual voltage is 154v. >When we measure each pack it's at 96v. and 2x96 should be 192, so it must >need a minimum of 2 packs to work. > > >-- >AF mailing list >AF@af.afmug.com <mailto:AF@af.afmug.com> >http://af.afmug.com/mailman/listinfo/af_af.afmug.com > > >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
