Yeah, I don't really see a good reason to not just use a surge suppressor. Cheap-rate Ubiquiti or Mimosa suppressors can be had for ~$10... and you obviously aren't going to care much about the quality of the actual surge suppression in this case anyway.
On Thu, Oct 7, 2021 at 12:28 PM Adam Moffett <[email protected]> wrote: > I guess both indoor and outdoor? Bonding for R56 compliance and also > for maybe getting RF noise to ground without going through our switch. > > I suppose indoor we can hack it, and outdoor might as well use the surge > suppressor. I'd imagine the housing and glands and such is more money > than the PCB so there's nothing gained by paring it down. > > -Adam > > > > On 10/7/2021 12:56 PM, Chuck McCown via AF wrote: > > Trim back the jacket and attach a ground wire. Are you wanting > > something for outdoor mounting? It would have to be two shielded > > jacks and you would have to use shielded plugs on it. So two jacks on > > a pcb and then some kind of housing. > > > > -----Original Message----- From: Adam Moffett > > Sent: Thursday, October 7, 2021 10:45 AM > > To: AnimalFarm Microwave Users Group > > Subject: [AFMUG] Ethernet ground block > > > > Is there an equivalent to the cable TV ground blocks but for Cat5? > > > > I would basically look like a coupler with a ground wire attached to the > > shield. Much more basic than a surge suppressor. > > > > -Adam > > > > > > > > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
