Yes, with the caveat that they changed some stuff in the 450i *AP* hardware which makes it incompatible with pipes before revision I0.
If it works and gets sync, it's good to go. If it doesn't, then you'll just need to find a syncpipe or syncbox I0 or later. (That's the letter I, it's kinda nice how that ended up landing = I0 = 450i. Would have been better if they hadn't mangled the sync port to need a different circuit, but that's the way it goes). On Thu, Jun 18, 2020 at 8:20 PM Mathew Howard <mhoward...@gmail.com> wrote: > The 900mhz PTP is definitely SM hardware. > Apparently I was wrong about them supporting sync over power... looks like > you would indeed need a timing port device. But in that case, any old sync > pipe should work, shouldn't it? > > > http://community.cambiumnetworks.com/t5/Sub-6-GHz/PTP450-900-BHM-Sync-Options/td-p/74379 > > I suspect we are actually talking about a PMP AP though, so we'd need to > clarify that > > On Thu, Jun 18, 2020 at 8:53 PM Forrest Christian (List Account) < > li...@packetflux.com> wrote: > >> I see that everyone else is as confused as I am about some of these PTP >> Radios. >> >> I'm about 100% certain that the 900Mhz PTP is be the AP hardware, in >> which case it should support any timing method you throw at it: Canopy >> sync, cambium sync, or aux port sync. >> >> For a single radio,the Syncbox Aux Port is probably the least expensive >> option, although I personally would throw the combination of a syncbox >> basic, sitemonitor base 3, and powerinjector+canopy sync at it as that will >> allow you to power and control any other radios at the site and gain >> temperature and telemetry for the site. >> >> On the syncbox only option, The Syncbox Aux Port get's its power from the >> radio, just turn on uGPS power in the AP, and run a cat5 from the aux port >> to this unit. >> >> If this isn't based on the AP hardware, then we need to go to plan B, >> which will probably be a timing port device, but I'll need to research more. >> >> On Thu, Jun 18, 2020 at 12:30 PM <cg...@graytechsoftware.com> wrote: >> >>> I have a site where I need sync only for a PTP 450i 900 MHz AP. Any >>> recommendation for which PacketFlux injector to use? >>> >>> [I have some old syncpipes, but they are not new enough.] >>> >>> Thank you, Chris >>> -- >>> AF mailing list >>> AF@af.afmug.com >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>> >> >> >> -- >> - Forrest >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- - Forrest
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
