The 900mhz PTP is definitely SM hardware. Apparently I was wrong about them supporting sync over power... looks like you would indeed need a timing port device. But in that case, any old sync pipe should work, shouldn't it?
http://community.cambiumnetworks.com/t5/Sub-6-GHz/PTP450-900-BHM-Sync-Options/td-p/74379 I suspect we are actually talking about a PMP AP though, so we'd need to clarify that On Thu, Jun 18, 2020 at 8:53 PM Forrest Christian (List Account) < li...@packetflux.com> wrote: > I see that everyone else is as confused as I am about some of these PTP > Radios. > > I'm about 100% certain that the 900Mhz PTP is be the AP hardware, in which > case it should support any timing method you throw at it: Canopy sync, > cambium sync, or aux port sync. > > For a single radio,the Syncbox Aux Port is probably the least expensive > option, although I personally would throw the combination of a syncbox > basic, sitemonitor base 3, and powerinjector+canopy sync at it as that will > allow you to power and control any other radios at the site and gain > temperature and telemetry for the site. > > On the syncbox only option, The Syncbox Aux Port get's its power from the > radio, just turn on uGPS power in the AP, and run a cat5 from the aux port > to this unit. > > If this isn't based on the AP hardware, then we need to go to plan B, > which will probably be a timing port device, but I'll need to research more. > > On Thu, Jun 18, 2020 at 12:30 PM <cg...@graytechsoftware.com> wrote: > >> I have a site where I need sync only for a PTP 450i 900 MHz AP. Any >> recommendation for which PacketFlux injector to use? >> >> [I have some old syncpipes, but they are not new enough.] >> >> Thank you, Chris >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > > > -- > - Forrest > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
