The easiest way would to buy an old phone from a thrift store if you can, unscrew the caps off of the handset and use the transmitter and receiver wires to interface the audio.
Sent from my iPhone > On Nov 7, 2018, at 9:40 AM, Nate Burke <n...@blastcomm.com> wrote: > > Unfortunately no cat5 to the soundboard, the aforementioned wall problem, so > I'm limited to WIFI. I should be able to put a phone on the end of a WIFI > Adapter though. Can you somehow wire an Analog Telephone plug so that it > would accept an RCA Jack input? Then I could just use an ATA. I found this > https://www.amazon.com/JK-Audio-THAT-1-Telephone-Handset/dp/B003D82WHK but it > looks pretty expensive for what I suspect are a few cents worth of > components. > >> On 11/7/2018 10:31 AM, ch...@wbmfg.com wrote: >> If you are not extremely interested in low latency or high quality. >> >> >> From: can...@believewireless.net >> Sent: Wednesday, November 7, 2018 9:23 AM >> To: AnimalFarm Microwave Users Group >> Subject: Re: [AFMUG] OT: Wireless Sound System monitor speaker >> >> I would use SIP with auto-answer. Connect a phone to the sound board and >> depending on the phone, >> either custom wire the handset jack or if it has a 3.5mm jack you could use >> that. Set the phone to >> auto answer and you could dial in from anywhere. >> >>> On Wed, Nov 7, 2018 at 11:18 AM Nate Burke <n...@blastcomm.com> wrote: >>> I'm trying to get a monitor speaker off a mixing board to a different >>> part of a building. 100+ year old construction, a 20" thick brick wall >>> between the mixing board and the endpoint, and a cable run of probably >>> 400-500' involving a lot of fishing of wires. I'm trying to come up with >>> a way to avoid running wires if I can. Straight line distance between >>> the 2 points is about 150' WIFI is available at the sound board, and a >>> hardline cat5 at the remote end, but I need something idiot proof that >>> just turns on and works. One thought was maybe a SIP Setup (there is >>> already a SIP Pbx in place), some sort of ATA that would connected to >>> the monitor out of the board then could be dialed from another SIP >>> Extension? Not sure if such a beast exists. >>> >>> I'd also be open to a simple wireless speaker, but would have to be low >>> enough frequency to operate at distance through a couple walls, so >>> Bluetooth is probably out. Audio quality is a secondary concern, it's >>> more of a "What's happening right now in the other room" need. Any of >>> you Pro Audio guys have any suggestions? >>> >>> -- >>> AF mailing list >>> AF@af.afmug.com >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> >> > > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
