Dear Richard, Thanks for your reply. Actually there is NO any other disk/controlller fault in this system. An engineer of NexentaStor, Andrew, just add a line in /kernel/drv/sd.conf of "allow-bus-device-reset=0" of the NexentaStor system and then the resilver speed get high. Before the parameter add-on, the system had resilver more than 2 days and not complete yet. After the engineer add-on that line and reboot the system, the reslver just spend about 10 hours to complete. Do you know what happen about it? Thanks!!
On Sun, Dec 26, 2010 at 1:24 PM, Richard Elling <richard.ell...@gmail.com>wrote: > On Dec 21, 2010, at 8:18 AM, Jackson Wang wrote: > > Dear Richard, > > I am a Nexenta user and now I meet the same problem of the resilver spend > too long time. I try to find out solution from the link on your content that > "zfs set resilver_speed=10% pool_name" but the Nexenta without the property > of resiler_speed. How can I slove my issue on Nexenta? Please advise. > Thanks! > > In general, resilver will take as long as needed. If your resilver is going > very, very slow, then there could be other issues causing the slowness. > Has the system been logging error messages related to the I/O subsystem > during the resilver? > -- richard > > -- InfoTech Technology Corp. 威傑科技有限公司 http://www.infowize.com.tw Jackson Wang 王仁傑 M: 0916163480 T:02-26791430 / 03-5834432 / 070-1020-9886 F:0940-472248 Tech Supp: supp...@infowize.com.tw Sales Supp: sa...@infowize.com.tw
_______________________________________________ zfs-discuss mailing list zfs-discuss@opensolaris.org http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
