Thanks for your reply, could you please explain how you get omnirig to sync them together? That sounds like what I want but I don’t know how to get omnirig to do that.
Although… the freq for the low IF rig (144) has a different offset frequency from 10GHz from the sdr (618MHz). It feels like, as well as the “radio” settings, which have an offset freq, wsjtx might need need a “monitor radio” settings or similar, so that you can specify a 2nd rig control method and 2nd offset freq… Rob > On 15 Jul 2022, at 02:23, Carey Fisher via wsjt-devel > <[email protected]> wrote: > > > I use FLRig to control my IC-7300 and SDRUno to control my SDR with Omnirig > optionally syncing the two together. > 73, Carey, WB4HXE > > >> On Thu, Jul 14, 2022 at 4:47 PM Rob O'Leary via wsjt-devel >> <[email protected]> wrote: >> Hi Alex, >> >> I have thought of doing something like this but I expect/hope that we >> are not the only people wanting to do sync a panadapter/rx SDR to their >> wsjtx band and so there might be a way to do it that I don't have to >> invent/code. >> >> Regards >> >> Rob >> >> On 14/07/2022 21:28, Alex Lelievre wrote: >> > Hi Rob, >> > >> > I’ve modified Hamlib so that when I switch frequency on my radio it also >> > sends a command to my SDR software to go to that frequency via CAT. I’m >> > sure there are tools out there that do this without the need to modify >> > existing software but figured I’d put it out there in case that helps you >> > slightly. >> > >> > best, >> > alex K6LOT >> > >> > >> >> On Jul 14, 2022, at 12:42 PM, Rob O'Leary via wsjt-devel >> >> <[email protected]> wrote: >> >> >> >> Hi >> >> >> >> I have searched the email list and the online user guide, so I hope I >> >> havent missed obvious documentation... >> >> >> >> We use wsjt-x to control an icom746 connected to a 10GHz transverter. We >> >> operate Q65-D for EME. We have fed a 618MHz receive IF to a receive only >> >> SDR to allow us to see a wider slice of spectrum (doppler etc), currently >> >> running spectravu. This IF is further down converted to 144MHz into the >> >> icom746 receive.) >> >> >> >> I think I could run 2 instances of wsjtx, 1 for the sdr and 1 for the >> >> icom746 but then if we change sked frequency in the eme settings, we >> >> would have to do it twice and soon mess it up! >> >> >> >> Please could you explain if there is a way to sync the SDR frequency to >> >> the doppler corrected rx freq that is sent to the icom746 and how to set >> >> this up? >> >> >> >> Thanks >> >> >> >> Rob >> >> >> >> >> >> >> >> _______________________________________________ >> >> wsjt-devel mailing list >> >> [email protected] >> >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >> >> >> _______________________________________________ >> wsjt-devel mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel > > > -- > Carey Fisher > [email protected] > > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
