Hi Alex,
I have thought of doing something like this but I expect/hope that we
are not the only people wanting to do sync a panadapter/rx SDR to their
wsjtx band and so there might be a way to do it that I don't have to
invent/code.
Regards
Rob
On 14/07/2022 21:28, Alex Lelievre wrote:
Hi Rob,
I’ve modified Hamlib so that when I switch frequency on my radio it also sends
a command to my SDR software to go to that frequency via CAT. I’m sure there
are tools out there that do this without the need to modify existing software
but figured I’d put it out there in case that helps you slightly.
best,
alex K6LOT
On Jul 14, 2022, at 12:42 PM, Rob O'Leary via wsjt-devel
<[email protected]> wrote:
Hi
I have searched the email list and the online user guide, so I hope I havent
missed obvious documentation...
We use wsjt-x to control an icom746 connected to a 10GHz transverter. We
operate Q65-D for EME. We have fed a 618MHz receive IF to a receive only SDR to
allow us to see a wider slice of spectrum (doppler etc), currently running
spectravu. This IF is further down converted to 144MHz into the icom746
receive.)
I think I could run 2 instances of wsjtx, 1 for the sdr and 1 for the icom746
but then if we change sked frequency in the eme settings, we would have to do
it twice and soon mess it up!
Please could you explain if there is a way to sync the SDR frequency to the
doppler corrected rx freq that is sent to the icom746 and how to set this up?
Thanks
Rob
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
