Hi Rob, I’ve modified Hamlib so that when I switch frequency on my radio it also sends a command to my SDR software to go to that frequency via CAT. I’m sure there are tools out there that do this without the need to modify existing software but figured I’d put it out there in case that helps you slightly.
best, alex K6LOT > On Jul 14, 2022, at 12:42 PM, Rob O'Leary via wsjt-devel > <[email protected]> wrote: > > Hi > > I have searched the email list and the online user guide, so I hope I havent > missed obvious documentation... > > We use wsjt-x to control an icom746 connected to a 10GHz transverter. We > operate Q65-D for EME. We have fed a 618MHz receive IF to a receive only SDR > to allow us to see a wider slice of spectrum (doppler etc), currently running > spectravu. This IF is further down converted to 144MHz into the icom746 > receive.) > > I think I could run 2 instances of wsjtx, 1 for the sdr and 1 for the icom746 > but then if we change sked frequency in the eme settings, we would have to do > it twice and soon mess it up! > > Please could you explain if there is a way to sync the SDR frequency to the > doppler corrected rx freq that is sent to the icom746 and how to set this up? > > Thanks > > Rob > > > > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
