Great, thanks, however, the problem I am having is WHERE to tell my router to open the ports to a given IP address. You see, I have another LAN running with the LynkSys DSL router which uses DMZ and also you can open certain ports within its firmware. No problems there, but the WebRamp is not as clear, or I'm just totally dumb (or both). But I cannot figure out where I must tell my router to open up.
Any other suggestions? Thanks, Rodrigo ----- Original Message ----- From: "MotorPsyko" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, December 11, 2001 2:57 PM Subject: RE: WebRamp 700s DSL router > First and foremost you have to map that port to somewhere... NAT is funny in > that you cant jsut tell it "this port is open to everything" at least not > the majority of nat applications I've worked with. if the machine you want > to get to is say 192.168.0.2 then you will have to tell the router that port > 5900 is open to ip 192.168.0.2... you generally HAVe to input a specific > IP... > > Now if you are trying to connect to more than one PC behind the firewall > it's a different story... > > Over and beyond the first IP it's difficult to do unless you can find > someway to remotely initiate a session the only way I know of to do this > easily is to map the port to one machine...vnc to that machine and then open > a vnc session on that machine to any others inside the firewall... > > I'm sure theres a way to specify what port to use in a client session but > i've never messed with it > (IE: map port 5901 to a different ip and specify 5901 on your client etc) > > Personally I have a win2k server setup with terminal services enabled so I > terminal into the server and vnc to any other machines on the LAN from > there....vnc works MUCH better in a terminal session by the way... > > YMMV > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Rodrigo > Villarreal > Sent: Tuesday, December 11, 2001 1:05 PM > To: [EMAIL PROTECTED] > Subject: WebRamp 700s DSL router > > > Hello, > > Does anyone out there uses a WebRamp 700s DSL router? I am having problems > configuring the firmware to open up ports >5800 and >5900. > > In short, when I try to connect to a PC inside the LAN from the outside, the > WebRamp is blocking the VCN access (it uses a firewall, of course). > > Any suggestions would be greately appreciated. > > Rodrigo > --------------------------------------------------------------------- > To unsubscribe, mail [EMAIL PROTECTED] with the line: > 'unsubscribe vnc-list' in the message BODY > See also: http://www.uk.research.att.com/vnc/intouch.html > --------------------------------------------------------------------- > --------------------------------------------------------------------- > To unsubscribe, mail [EMAIL PROTECTED] with the line: > 'unsubscribe vnc-list' in the message BODY > See also: http://www.uk.research.att.com/vnc/intouch.html > --------------------------------------------------------------------- --------------------------------------------------------------------- To unsubscribe, mail [EMAIL PROTECTED] with the line: 'unsubscribe vnc-list' in the message BODY See also: http://www.uk.research.att.com/vnc/intouch.html ---------------------------------------------------------------------
