Hard to tell exactly. Interface between FX3 and FPGA could be the culprit. FX3 could be the culprit or the FPGA.
Sent from my iPhone > On Jul 11, 2022, at 3:44 PM, pro jason <jason_p...@outlook.com> wrote: > > > Hi Marcus, > > This board was bought a year ago, so it is out of warranty. > Is the FPGA chip broken? > > Best regards, > Jason > From: Marcus D Leech <patchvonbr...@gmail.com> > Sent: Tuesday, July 12, 2022 3:29 AM > To: pro jason <jason_p...@outlook.com> > Cc: USRP-users@lists.ettus.com <USRP-users@lists.ettus.com> > Subject: Re: [USRP-users] RuntimeError: fx3 is in state 5 > > Unfortunately this likely > Means you have broken hardware. > > If it was Purchased less than one year ago, send a note to supp...@ettus.com > for warranty support. > > Sent from my iPhone > >>> On Jul 11, 2022, at 3:26 PM, pro jason <jason_p...@outlook.com> wrote: >>> >> >> Hi Marcus, >> >> Thank you for your reply. >> The image file we use is a standard image file from Ettus Research, which >> has not been modified. >> We have several pcs of B200mini-i, and only one device reports this error. >> >> Best regards, >> Jason >> >> >> >> From: Marcus D. Leech <patchvonbr...@gmail.com> >> Sent: Sunday, June 12, 2022 2:42 AM >> To: pro jason <jason_p...@outlook.com> >> Subject: Re: [USRP-users] RuntimeError: fx3 is in state 5 >> >>> On 2022-06-11 13:24, pro jason wrote: >>> Hi all, >>> >>> One of our b200mini-i is not working properly. The faults are as follows: >>> >>> uhd_usrp_probe >>> [INFO] [UHD] linux; GNU C++ version 7.5.0; Boost_106501; >>> UHD_4.2.0.HEAD-0-g46a70d85 >>> [INFO] [B200] Loading firmware image: >>> /usr/local/share/uhd/images/usrp_b200_fw.hex... >>> [INFO] [B200] Detected Device: B200mini >>> [INFO] [B200] Loading FPGA image: >>> /usr/local/share/uhd/images/usrp_b200mini_fpga.bin... >>> Error: RuntimeError: fx3 is in state 5 >>> >>> We tried to replace the computer or USB cable, but the fault still exists. >>> Is there a solution? If the hardware is damaged, which chip is likely to >>> fail? >>> >>> Best regards, >>> Jason >>> >>> >>> _______________________________________________ >>> USRP-users mailing list -- usrp-users@lists.ettus.com >>> To unsubscribe send an email to usrp-users-le...@lists.ettus.com >> Make sure your FPGA image is correct--is it the same as on other working >> systems? >> >> That error message indicates that the FX3 chip (USB interface) was unable to >> load the FPGA image--either because >> the FPGA isn't responding correctly, or there's something wrong with the >> image. >> >>
_______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com To unsubscribe send an email to usrp-users-le...@lists.ettus.com
