Hi Marcus, This board was bought a year ago, so it is out of warranty. Is the FPGA chip broken?
Best regards, Jason ________________________________ From: Marcus D Leech <patchvonbr...@gmail.com> Sent: Tuesday, July 12, 2022 3:29 AM To: pro jason <jason_p...@outlook.com> Cc: USRP-users@lists.ettus.com <USRP-users@lists.ettus.com> Subject: Re: [USRP-users] RuntimeError: fx3 is in state 5 Unfortunately this likely Means you have broken hardware. If it was Purchased less than one year ago, send a note to supp...@ettus.com for warranty support. Sent from my iPhone On Jul 11, 2022, at 3:26 PM, pro jason <jason_p...@outlook.com> wrote: Hi Marcus, Thank you for your reply. The image file we use is a standard image file from Ettus Research, which has not been modified. We have several pcs of B200mini-i, and only one device reports this error. Best regards, Jason ________________________________ From: Marcus D. Leech <patchvonbr...@gmail.com> Sent: Sunday, June 12, 2022 2:42 AM To: pro jason <jason_p...@outlook.com> Subject: Re: [USRP-users] RuntimeError: fx3 is in state 5 On 2022-06-11 13:24, pro jason wrote: Hi all, One of our b200mini-i is not working properly. The faults are as follows: uhd_usrp_probe [INFO] [UHD] linux; GNU C++ version 7.5.0; Boost_106501; UHD_4.2.0.HEAD-0-g46a70d85 [INFO] [B200] Loading firmware image: /usr/local/share/uhd/images/usrp_b200_fw.hex... [INFO] [B200] Detected Device: B200mini [INFO] [B200] Loading FPGA image: /usr/local/share/uhd/images/usrp_b200mini_fpga.bin... Error: RuntimeError: fx3 is in state 5 We tried to replace the computer or USB cable, but the fault still exists. Is there a solution? If the hardware is damaged, which chip is likely to fail? Best regards, Jason _______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com<mailto:usrp-users@lists.ettus.com> To unsubscribe send an email to usrp-users-le...@lists.ettus.com<mailto:usrp-users-le...@lists.ettus.com> Make sure your FPGA image is correct--is it the same as on other working systems? That error message indicates that the FX3 chip (USB interface) was unable to load the FPGA image--either because the FPGA isn't responding correctly, or there's something wrong with the image.
_______________________________________________ USRP-users mailing list -- usrp-users@lists.ettus.com To unsubscribe send an email to usrp-users-le...@lists.ettus.com
