Hello everyone,
I had some trouble with my X310 and I needed to upload my UHD
installation and consequently to update the FPGA image on the board.
After doing it through eternet port, I lost connection so I decide to
follow the recovery procedure to upload the FPGA image using the JTAG
port (following https://kb.ettus.com/X300/X310_Device_Recovery).
The upload is fine, and the computer recognises the network with IP
address 192.168.10.1, but when I try to ping 192.168.10.2 (as explained
in the procedure) I have
PING 192.168.10.3 (192.168.10.3) 56(84) bytes of data.
From 192.168.10.1 icmp_seq=1 Destination Host Unreachable
From 192.168.10.1 icmp_seq=2 Destination Host Unreachable
From 192.168.10.1 icmp_seq=3 Destination Host Unreachable
From 192.168.10.1 icmp_seq=4 Destination Host Unreachable
From 192.168.10.1 icmp_seq=5 Destination Host Unreachable
until I stop it. I have two x310 in the same situation, and I tried on
two different computers with different ethernet cables.
Could the hardware be broken ? (If so, isn't it strange that the
computer still sees the network ?)
Thanks a lot, and nice week end !
Kind regards,
Nicolas
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
