Hi Mark, The UBX v2 is not supported using UHD 3.9.3. Support for the UBX v2 was added with UHD 3.9.5 and UHD 3.10.2.0. Can you please try updating to the newest UHD, such as 3.9.7 or 3.10.2.0 and try probing USRP/DBs again?
Regards, Nate Temple On Tue, Oct 17, 2017 at 1:01 PM, Mark Koenig via USRP-users < usrp-users@lists.ettus.com> wrote: > Hello, > > > > I am looking for some help with respect to the UBX-160. I have two > version 2 daughtercards which were purchased a couple of months ago. > > > > I am running on CentOS 7.2 and CentOS 6.5 with GNU radio version 3.7.4 and > UHD version 003.009.003. > > > > I can ping the USRP and also return information on the *uhd_find_devices* > command, however, when I run the *uhd_usrp_probe *command I do not get a > return for the daughtercards. The example output is below. > > > > Any help would be EXTREMELY appreciated. > > > > Thank you > > Mark > > > > linux; GNU C++ version 4.4.7 20120313 (Red Hat 4.4.7-16); Boost_105300; > UHD_003.009.004-0-g2b5a88bb > > > > -- X300 initialization sequence... > > -- Determining maximum frame size... 1472 bytes. > > -- Setup basic communication... > > -- Loading values from EEPROM... > > -- Setup RF frontend clocking... > > -- Radio 1x clock:200 > > -- Detecting internal GPSDO.... Found an internal GPSDO > > -- Initialize Radio0 control... > > -- Performing register loopback test... pass > > -- Initialize Radio1 control... > > -- Performing register loopback test... pass > > _____________________________________________________ > > / > > | Device: X-Series Device > > | _____________________________________________________ > > | / > > | | Mboard: X310 > > | | revision: 11 > > | | revision_compat: 7 > > | | product: 30818 > > | | mac-addr0: 00:80:2f:17:43:3f > > | | mac-addr1: 00:80:2f:17:43:40 > > | | gateway: 192.168.10.1 > > | | ip-addr0: 192.168.10.2 > > | | subnet0: 255.255.255.0 > > | | ip-addr1: 192.168.20.2 > > | | subnet1: 255.255.255.0 > > | | ip-addr2: 192.168.30.2 > > | | subnet2: 255.255.255.0 > > | | ip-addr3: 192.168.40.2 > > | | subnet3: 255.255.255.0 > > | | serial: 311FF4E > > | | FW Version: 4.0 > > | | FPGA Version: 19.0 > > | | > > | | Time sources: internal, external, gpsdo > > | | Clock sources: internal, external, gpsdo > > | | Sensors: gps_gpgga, gps_gprmc, gps_time, gps_locked, gps_servo, > ref_locked > > | | _____________________________________________________ > > | | / > > | | | RX DSP: 0 > > | | | Freq range: -100.000 to 100.000 MHz > > | | _____________________________________________________ > > | | / > > | | | RX DSP: 1 > > | | | Freq range: -100.000 to 100.000 MHz > > | | _____________________________________________________ > > | | / > > | | | RX Dboard: A > > | | | ID: Unknown (0x007e) > > | | | Serial: 3120D56 > > | | | _____________________________________________________ > > | | | / > > | | | | RX Frontend: 0 > > | | | | Name: Unknown (0x007e) - 0 > > | | | | Antennas: > > | | | | Sensors: > > | | | | Freq range: 0.000 to 0.000 MHz > > | | | | Gain Elements: None > > | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz > > | | | | Connection Type: IQ > > | | | | Uses LO offset: No > > | | | _____________________________________________________ > > | | | / > > | | | | RX Codec: A > > | | | | Name: ads62p48 > > | | | | Gain range digital: 0.0 to 6.0 step 0.5 dB > > | | _____________________________________________________ > > | | / > > | | | RX Dboard: B > > | | | ID: Unknown (0x007e) > > | | | Serial: 3120D4A > > | | | _____________________________________________________ > > | | | / > > | | | | RX Frontend: 0 > > | | | | Name: Unknown (0x007e) - 0 > > | | | | Antennas: > > | | | | Sensors: > > | | | | Freq range: 0.000 to 0.000 MHz > > | | | | Gain Elements: None > > | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz > > | | | | Connection Type: IQ > > | | | | Uses LO offset: No > > | | | _____________________________________________________ > > | | | / > > | | | | RX Codec: B > > | | | | Name: ads62p48 > > | | | | Gain range digital: 0.0 to 6.0 step 0.5 dB > > | | _____________________________________________________ > > | | / > > | | | TX DSP: 0 > > | | | Freq range: -100.000 to 100.000 MHz > > | | _____________________________________________________ > > | | / > > | | | TX DSP: 1 > > | | | Freq range: -100.000 to 100.000 MHz > > | | _____________________________________________________ > > | | / > > | | | TX Dboard: A > > | | | ID: Unknown (0x007d) > > | | | Serial: 3120D56 > > | | | _____________________________________________________ > > | | | / > > | | | | TX Frontend: 0 > > | | | | Name: Unknown (0x007d) - 0 > > | | | | Antennas: > > | | | | Sensors: > > | | | | Freq range: 0.000 to 0.000 MHz > > | | | | Gain Elements: None > > | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz > > | | | | Connection Type: IQ > > | | | | Uses LO offset: No > > | | | _____________________________________________________ > > | | | / > > | | | | TX Codec: A > > | | | | Name: ad9146 > > | | | | Gain Elements: None > > | | _____________________________________________________ > > | | / > > | | | TX Dboard: B > > | | | ID: Unknown (0x007d) > > | | | Serial: 3120D4A > > | | | _____________________________________________________ > > | | | / > > | | | | TX Frontend: 0 > > | | | | Name: Unknown (0x007d) - 0 > > | | | | Antennas: > > | | | | Sensors: > > | | | | Freq range: 0.000 to 0.000 MHz > > | | | | Gain Elements: None > > | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz > > | | | | Connection Type: IQ > > | | | | Uses LO offset: No > > | | | _____________________________________________________ > > | | | / > > | | | | TX Codec: B > > | | | | Name: ad9146 > > > > > > > > > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com > >
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
