Have you seen these (I've not played with them myself): the joinStyle of graphic ... > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Specifies how corners between lines are drawn. It can be one of the > following: > - bevel: a straight line is drawn between the outer edges of the > adjoining lines > - round: a circular arc is drawn between the outer edges of the > adjoining lines > - miter: outer edges are extended to meet at a sharp point. If the > distance from the corner exceeds the miter limit (see below), a bevel join > is used for the corner. > > Note: This only affects polygon, freehand curve and line graphics which > have their antialiased set to true. > > > the miterLimit of graphic ... > ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Specifies how much miter joins are allowed to extend beyond the meeting > point of the two lines. The miterLimit is specified as a real multiple of > the line width. > > Note: This only affects polygon, freehand curve and line graphics which > have their antialiased set to true. > > > the capStyle of graphic ... > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Specifies how the line ends (and dash ends) will be drawn. It can be one > of the following: > - butt: no cap is added > - square: the edge is extended beyond the end-point by half the line > width > - round: lines are ended by a half-circle centered at the end point of > the line > > Note: This only affects polygon, freehand curve and line graphics which > have their antialiased set to true. >
On 1 December 2010 15:48, Richmond <richmondmathew...@gmail.com> wrote: > What follows is a personal fantasy: > > on mouseUp > set the roundRadius of parameter 1 of graphic "WONKY" to 0 > set the roundRadius of parameter 2 of graphic "WONKY" to 0 > set the roundRadius of parameter 3 of graphic "WONKY" to 50 > set the roundRadius of parameter 4 of graphic "WONKY" to 50 > end mouseUp > > SADLY, it is ONLY a fantasy . . . :( > Or a sad fantasy :) _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode
