Charles That is interesting. Any clue how to configure the start and end blocks manually?
Bud > -----Original Message----- > From: Charles Manning [mailto:mannin...@actrix.gen.nz] > Sent: Monday, 12 March 2012 8:20 a.m. > To: Bud Miljkovic > Cc: u-boot@lists.denx.de > Subject: Re: [U-Boot] Enabling nand createbbt command > > Bud > > Yaffs can work without mtdpart. To do that you just need to configure > the > start and end blocks manually instead of using the partition info to do > this. > > On Friday 09 March 2012 13:58:48 Bud Miljkovic wrote: > > Thank you Scott and Fabio, > > > > You help is much appreciated. > > > > I will try to add the nand support for mx53 mainline. > > > > However, what I am trying to do is to build a u-boot that supports > NAND > > and have YAFFS2 as well and at moment I use the mx53_ard board since > > this is very close to what my custom board will be. I was able to > build > > such a version, using Freescale u-boot sources, which included nand > > subsystem, and yaffs commands. Then I needed to create partitions in > > the nand and this is where i "discovered" I needed the support of > > mtdparts command. > > > > So I, guess, I need to configure the u-boot for mtdparts support. > This > > is where I am at. > > > > -Bud > > > > > -----Original Message----- > > > From: Scott Wood > > > Sent: Friday, 9 March 2012 12:04 p.m. > > > To: Bud Miljkovic > > > Cc: Fabio Estevam; > > > > > > Subject: Re: [U-Boot] Enabling nand createbbt command > > > > > > I do expect mainline is better maintained and supported, except for > > > missing particular features/hardware support that nobody ever > bothered > > > > > > to submit to mainline -- which in this case appears to be hardware > > > that you care about, so unless you're prepared to do a fair bit of > > > work to add support to mainline, I'd try again to find a support > > > channel for your Freescale-provided U-Boot. Or maybe we could help > > > you figure out what it is you want to do, instead of scrubbing, if > the > > > > > > answer doesn't depend on details of a non-standard U-Boot. > > > > > > Oh, and if you're curious about my freescale.com e-mail address, I > > > work in a different part of the company and don't have i.MX > knowledge > > > or contacts. > > > > > > -Scott > > > > _______________________________________________ > > U-Boot mailing list > > U-Boot@lists.denx.de > > http://lists.denx.de/mailman/listinfo/u-boot > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
