On 03/08/2012 03:01 PM, Bud Miljkovic wrote: > >> -----Original Message----- >> From: Scott Wood [mailto:scottw...@freescale.com] >> Sent: Friday, 9 March 2012 9:02 a.m. >> To: Bud Miljkovic >> Cc: u-boot@lists.denx.de >> Subject: Re: [U-Boot] Enabling nand createbbt command >> >> >> It should happen automatically when nand_erase_opts() calls >> chip->scan_bbt(), provided the driver set the NAND_USE_FLASH_BBT flag, >> and that NAND_BBT_CREATE/NAND_BBT_WRITE are set in the nand_bbt_descr >> (this is the case if the driver doesn't override the default >> nand_bbt_descr). >> >> Are you not seeing it happen? What version of U-Boot are you using, >> with which NAND controller driver? > > I am using u-boot-2009.08 sources from Freescale released under SABRE > Automotive Infotainment board aka mx53_ard.
Please use a recent upstream U-Boot, or contact supp...@freescale.com for support with your Freescale-supplied code. > Looking at this from the u-boot commands prospective, > - I get "nand - NAND sub-system" but it does not recognize "nand > createbbt" command Is there a reason you're expecting it to exist? > I am fairly newbee in this and would not know which NAND controller > driver is used. Why are you using the scrub command? It's an "I know what I'm doing" backdoor. There's even a warning, with confirmation prompt, telling you it's dangerous and to only use it "if you are sure of what you are doing". -Scott _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
