On 11/08/11 17:28, Tom Rini wrote:
> On 11/08/2011 12:57 AM, Igor Grinberg wrote:
>> On 11/07/11 22:05, Tom Rini wrote:
>>> This introduces 200MHz Micron parts timing information based on x-loader
>>> to <asm/arch-omap3/mem.h>. The memory init logic is also based on what
>>> x-loader does in these cases. Note that while previously u-boot would
>>> be flashed in with SW ECC in this case it now must be flashed with HW
>>> ECC.
> [snip]
>>> +#ifdef CONFIG_SPL_BUILD
>>> +/*
>>> + * Routine: board_early_sdrc_init
>>
>> s/board_early_sdrc_init/get_board_mem_timings/
>>
>>> + * Description: If we use SPL then there is no x-loader nor config header
>>> + * so we have to setup the DDR timings outself on both banks.
>>
>> s/outself/ourself/
>
> Thanks.
>
> [snip]
>>> + case REVISION_C4:
>>> + if ((pop_mfr == NAND_MFR_STMICRO) && (pop_id == 0xba)) {
>>
>> No need for extra parenthesis.
>
> I'll double check all these cases, thanks.
>
>>> + *mcfg = 0x04590099;
>>> + *ctrla = NUMONYX_V_ACTIMA_165;
>>> + *ctrlb = NUMONYX_V_ACTIMB_165;
>>> + *rfr_ctrl = SDP_3430_SDRC_RFR_CTRL_165MHz;
>>
>> This will look much better if it will be aligned.
>
> It's not in CodingStyle tho ;)
Right, you don't have to, but it will look better...
>
> [snip]
>>> -# For use with external or internal boots.
>>> -CONFIG_SYS_TEXT_BASE = 0x80008000
>>
>> Removing needless crap is a very good thing, but does not
>> belong to this patch, is it?
>
> I thought I said in this commit message, but I know I did for am3517
> evm/crane, we change CONFIG_SYS_TEXT_BASE which is why we remove this
> file here. It could be done as a two-step if it's a hard objection tho.
Yeah, I've sent this email before I saw the AM3517 changes.
Ok.
--
Regards,
Igor.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
