On 11/08/2011 12:57 AM, Igor Grinberg wrote:
> On 11/07/11 22:05, Tom Rini wrote:
>> This introduces 200MHz Micron parts timing information based on x-loader
>> to <asm/arch-omap3/mem.h>. The memory init logic is also based on what
>> x-loader does in these cases. Note that while previously u-boot would
>> be flashed in with SW ECC in this case it now must be flashed with HW
>> ECC.
[snip]
>> +#ifdef CONFIG_SPL_BUILD
>> +/*
>> + * Routine: board_early_sdrc_init
>
> s/board_early_sdrc_init/get_board_mem_timings/
>
>> + * Description: If we use SPL then there is no x-loader nor config header
>> + * so we have to setup the DDR timings outself on both banks.
>
> s/outself/ourself/
Thanks.
[snip]
>> + case REVISION_C4:
>> + if ((pop_mfr == NAND_MFR_STMICRO) && (pop_id == 0xba)) {
>
> No need for extra parenthesis.
I'll double check all these cases, thanks.
>> + *mcfg = 0x04590099;
>> + *ctrla = NUMONYX_V_ACTIMA_165;
>> + *ctrlb = NUMONYX_V_ACTIMB_165;
>> + *rfr_ctrl = SDP_3430_SDRC_RFR_CTRL_165MHz;
>
> This will look much better if it will be aligned.
It's not in CodingStyle tho ;)
[snip]
>> -# For use with external or internal boots.
>> -CONFIG_SYS_TEXT_BASE = 0x80008000
>
> Removing needless crap is a very good thing, but does not
> belong to this patch, is it?
I thought I said in this commit message, but I know I did for am3517
evm/crane, we change CONFIG_SYS_TEXT_BASE which is why we remove this
file here. It could be done as a two-step if it's a hard objection tho.
--
Tom
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
