Hi, Am Di., 24. Sept. 2024 um 08:38 Uhr schrieb Devarsh Thakkar <devar...@ti.com >:
> > CONFIG_FDT_SIMPLEFB is only used in splash-screen context which in-turn > depends on CONFIG_VIDEO. So CONFIG_FDT_SIMPLEFB is in a way dependent on > CONFIG_VIDEO. We had fixed similar issue in past in vendor tree and by > making > CONFIG_FDT_SIMPLEFB dependent on CONFIG_VIDEO using below set of patches > [1] > which I was planning to post upstream too. > > Kindly let me know If these patches look good to you and fix your problem > too, > I can post same set of patches to upstream too. > > [1] : > > https://git.ti.com/cgit/ti-u-boot/ti-u-boot/commit/?h=ti-u-boot-2024.04&id=1199800505f11f2162030cb641c6d0c9276d5c9c > [2] : > > https://git.ti.com/cgit/ti-u-boot/ti-u-boot/commit/?h=ti-u-boot-2024.04&id=5b4b8eac243cbd86286ff2cf57ca0469c4d86345 > > These patches look good to me. If I understand the code correctly the frame buffer node should only be created if CONFIG_FDT_SIMPLEFB is enabled. Thus I would change the code like this: Signed-off-by: Martin Stolpe <martin.sto...@gmail.com> --- board/raspberrypi/rpi/rpi.c | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) diff --git a/board/raspberrypi/rpi/rpi.c b/board/raspberrypi/rpi/rpi.c index ab5ea85cf9..47db441696 100644 --- a/board/raspberrypi/rpi/rpi.c +++ b/board/raspberrypi/rpi/rpi.c @@ -569,11 +569,13 @@ int ft_board_setup(void *blob, struct bd_info *bd) update_fdt_from_fw(blob, (void *)fw_dtb_pointer); - node = fdt_node_offset_by_compatible(blob, -1, "simple-framebuffer"); - if (node < 0) - fdt_simplefb_add_node(blob); - else - fdt_simplefb_enable_and_mem_rsv(blob); + if (CONFIG_IS_ENABLED(FDT_SIMPLEFB)) { + node = fdt_node_offset_by_compatible(blob, -1, "simple-framebuffer"); + if (node < 0) + fdt_simplefb_add_node(blob); + else + fdt_simplefb_enable_and_mem_rsv(blob); + } #ifdef CONFIG_EFI_LOADER /* Reserve the spin table */ -- 2.43.0 What do you think? Regards Martin