Hi Tim On Wed, Apr 13, 2022 at 5:47 PM Tim Harvey <thar...@gateworks.com> wrote: > > Enable DM_SERIAL. > > Signed-off-by: Tim Harvey <thar...@gateworks.com> > --- > v2: rebase on imx/master > --- > configs/imx8mm_venice_defconfig | 2 ++ > configs/imx8mn_venice_defconfig | 2 ++ > 2 files changed, 4 insertions(+) > > diff --git a/configs/imx8mm_venice_defconfig b/configs/imx8mm_venice_defconfig > index dd61ec9b70fb..09f7d8a58ca7 100644 > --- a/configs/imx8mm_venice_defconfig > +++ b/configs/imx8mm_venice_defconfig > @@ -110,6 +110,8 @@ CONFIG_SPL_DM_PMIC_MP5416=y > CONFIG_DM_REGULATOR=y > CONFIG_DM_REGULATOR_FIXED=y > CONFIG_DM_REGULATOR_GPIO=y > +CONFIG_DM_SERIAL=y > +# CONFIG_SPL_DM_SERIAL is not set > CONFIG_MXC_UART=y > CONFIG_SYSRESET=y > CONFIG_SPL_SYSRESET=y > diff --git a/configs/imx8mn_venice_defconfig b/configs/imx8mn_venice_defconfig > index c3a96a378553..41898da4aecf 100644 > --- a/configs/imx8mn_venice_defconfig > +++ b/configs/imx8mn_venice_defconfig > @@ -108,6 +108,8 @@ CONFIG_SPL_DM_PMIC_MP5416=y > CONFIG_DM_REGULATOR=y > CONFIG_DM_REGULATOR_FIXED=y > CONFIG_DM_REGULATOR_GPIO=y > +CONFIG_DM_SERIAL=y > +# CONFIG_SPL_DM_SERIAL is not set > CONFIG_MXC_UART=y > CONFIG_SYSRESET=y > CONFIG_SPL_SYSRESET=y > -- > 2.17.1 >
Should not select in your board kconfig? Michael -- Michael Nazzareno Trimarchi Co-Founder & Chief Executive Officer M. +39 347 913 2170 mich...@amarulasolutions.com __________________________________ Amarula Solutions BV Joop Geesinkweg 125, 1114 AB, Amsterdam, NL T. +31 (0)85 111 9172 i...@amarulasolutions.com www.amarulasolutions.com
