Dear stefano babic,
In message <4cb479a1.6060...@denx.de> you wrote:
>
> > Normally one defines a default command here ?
>
> Probably I misunderstand its usage, but my intention is to enable the
> PREBOOT feature, but let the user to decide with the "preboot" variable
> if it is required or not. In my case for this board, I use it to load an
> image from a NAND device, as "splashimage" can be used only with an address.
No, you did not misinderstand. Everything is fine if this was your
intention. I just wantred to make that sure, as most people define
some default command here.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
We fight only when there is no other choice. We prefer the ways of
peaceful contact.
-- Kirk, "Spectre of the Gun", stardate 4385.3
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
