On Mon, Jul 29, 2019 at 11:54 AM Marek Vasut <ma...@denx.de> wrote:
>
> On 7/29/19 6:05 PM, Adam Ford wrote:
> > On Mon, Jul 29, 2019 at 9:38 AM Marek Vasut <ma...@denx.de> wrote:
> >>
> >> On 7/29/19 3:19 PM, Adam Ford wrote:
> >>> On Mon, Jul 29, 2019 at 7:30 AM Marek Vasut <ma...@denx.de> wrote:
> >>>>
> >>>> On 7/29/19 2:16 PM, Adam Ford wrote:
> >>>>> On Sun, Jun 30, 2019 at 5:21 PM Adam Ford <aford...@gmail.com> wrote:
> >>>>>>
> >>>>>> The omap3.dtsi file shows the usbhshost node with two sub-nodes
> >>>>>> for ohci and ehci. This patch file creates the usbhshost, and
> >>>>>> pulls the portX-mode information. It then locates the EHCI
> >>>>>> sub-node, and initializes the EHCI controller with the info
> >>>>>> pulled from the usbhshost node.
> >>>>>>
> >>>>>> There is still more to do since there isn't an actual link
> >>>>>> between the 'phys' reference and the corresponding phy driver,
> >>>>>> and there is no nop-xceiv driver yet.
> >>>>>>
> >>>>>> In the meantime, the older style reference to
> >>>>>> CONFIG_OMAP_EHCI_PHYx_RESET_GPIO is still needed to pull
> >>>>>> the phy out of reset until the phy driver is completed and the
> >>>>>> phandle reference is made.
> >>>>>>
> >>>>>> Signed-off-by: Adam Ford <aford...@gmail.com>
> >>>>>>
> >>>>>
> >>>>> Marek,
> >>>>>
> >>>>> Some subsequent patches that were depending on this have been applied
> >>>>> already, but they cannot be really useful until this patch is applied.
> >>>>> Is there any chance it can be applied? It will give some of the OMAP3
> >>>>> boards the USB EHCI functionality which has been lost for a little
> >>>>> while.
> >>>>
> >>>> Sure, I am kinda busy and don't have enough free time to cope with this.
> >>>> Moreover, u-boot-usb/master fails to build:
> >>>> https://travis-ci.org/marex/u-boot-usb/builds/563567738
> >>>>
> >>>> Can you take a look whether it's this patchset that causes it ?
> >>>
> >>> Marek,
> >>>
> >>> I looked at the Travis logs, and it looks like the da850evm_nand and
> >>> da850evm_direct_nor were failing, so I tried to clone
> >>> git clone --depth=50 --branch=master
> >>> https://github.com/marex/u-boot-usb.git marex/u-boot-usb based on line
> >>> 846 of the Travis log.
> >>>
> >>> When I built da850evm_nand and da850evm_direct_nor, I could not
> >>> replicate either the build error.
> >>
> >> I see, strange, I can replicate the error.
> >>
> >> $ make da850evm_nand_defconfig ; make -j9
> >> ...
> >> drivers/usb/host/ohci-hcd.c: In function ‘usb_lowlevel_init’:
> >> drivers/usb/host/ohci-hcd.c:2056:35: error:
> >> ‘CONFIG_SYS_USB_OHCI_REGS_BASE’ undeclared (first use in this function);
> >> did you mean ‘CONFIG_SYS_USB_OHCI_CPU_INIT’?
> >> gohci.regs = (struct ohci_regs *)CONFIG_SYS_USB_OHCI_REGS_BASE;
> >> ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> >> CONFIG_SYS_USB_OHCI_CPU_INIT
> >> drivers/usb/host/ohci-hcd.c:2056:35: note: each undeclared identifier is
> >> reported only once for each function it appears in
> >> LD drivers/usb/musb-new/built-in.o
> >> drivers/usb/host/ohci-hcd.c:2060:20: error:
> >> ‘CONFIG_SYS_USB_OHCI_SLOT_NAME’ undeclared (first use in this function);
> >> did you mean ‘CONFIG_SYS_USB_OHCI_CPU_INIT’?
> >> gohci.slot_name = CONFIG_SYS_USB_OHCI_SLOT_NAME;
> >> ^~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> >> CONFIG_SYS_USB_OHCI_CPU_INIT
> >> LD drivers/mtd/spi/spi-nor.o
> >> make[1]: *** [scripts/Makefile.build:279: drivers/usb/host/ohci-hcd.o]
> >> Error 1
> >> make: *** [Makefile:1594: drivers/usb/host] Error 2
> >> make: *** Waiting for unfinished jobs....
> >>
> >
> > aford@aford-OptiPlex-7050:~/src/marex/u-boot-usb$ make
> > da850evm_nand_defconfig
> > HOSTCC scripts/basic/fixdep
> > HOSTCC scripts/kconfig/conf.o
> > YACC scripts/kconfig/zconf.tab.c
> > LEX scripts/kconfig/zconf.lex.c
> > HOSTCC scripts/kconfig/zconf.tab.o
> > HOSTLD scripts/kconfig/conf
> > #
> > # configuration written to .config
> > #
> > aford@aford-OptiPlex-7050:~/src/marex/u-boot-usb$ make ARCH=arm
> > CROSS_COMPILE="arm-linux-" -j8
> > scripts/kconfig/conf --syncconfig Kconfig
> > CHK include/config.h
>
> Are you sure you're building the correct tree ?
>
> The current top commit is 9812437f976c025775ddd36eede30605d0607ba8
Git log shows:
commit 9812437f976c025775ddd36eede30605d0607ba8 (HEAD -> master,
origin/master, origin/HEAD)
Author: Sam Protsenko <semen.protse...@linaro.org>
Date: Wed Jul 3 19:34:07 2019 +0300
fastboot: Remove "bootloader-version" variable
As per [1], there is no such fastboot variable as "bootloader-version".
Only "version-bootloader" is supported. Let's reflect this and not
confuse users further.
[1]
https://android.googlesource.com/platform/system/core/+/refs/tags/android-q-preview-4/fastboot/README.md
Fixes: 3aab70afc531d1 ("usb/gadget: add the fastboot gadget")
Signed-off-by: Sam Protsenko <semen.protse...@linaro.org>
Reviewed-by: Eugeniu Rosca <ero...@de.adit-jv.com>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
