Hi Alex, > On Tue, Jan 8, 2019 at 10:52 PM Lukasz Majewski <lu...@denx.de> wrote: > > > > Hi Alex, > > > > > On Thu, Dec 27, 2018 at 3:49 PM Tom Rini <tr...@konsulko.com> > > > wrote: > > > > > > > > On Tue, Dec 18, 2018 at 12:30:50PM +0100, Lukasz Majewski wrote: > > > > > > > > > This commit prevents from re-configuring pins if those were > > > > > configured before relocation. > > > > > > > > > > Some pins - like UART or DDR must be setup before relocation > > > > > (as they have 'u-boot,dm-pre-reloc' property set in DTS). > > > > > Without this change, those pins are re-configured after > > > > > relocation (pre_reloc_only = 0, so we do not "continue"). > > > > > Such behavior may be a problem for DDR PAD configuration, as > > > > > they might be already leveled/tuned with original setup). > > > > > > > > > > Signed-off-by: Lukasz Majewski <lu...@denx.de> > > > > > > > > Applied to u-boot/master, thanks! > > > > > > > > > > I've bisected out to this commit and it's slightly broken things > > > for me on an AM3352. It all works fine so long as I boot MLO from > > > MMC (so the MMC is probed, pinctrl setup), but if I boot from > > > UART then I get to full U-Boot, MMC hasn't been probed and the > > > pinmuxing isn't set up for the MMC. > > > > I suppose that the pinmux node have set "u-boot,dm-pre-reloc" > > property? > > > > Yeah, well "u-boot,dm-spl", though now I re-read the docs I guess > that's equivalent to "u-boot,dm-pre-reloc" as I've no TPL.
I do need to check this -> as in my case I do have "u-boot,dm-pre-reloc" property. And yes, in my case I do not have TPL too (just SPL). > > > The problem is not with lack of eMMC probing - it is with pinctrl > > nodes having "u-boot,dm-pre-reloc" set in DTS and the eMMC is > > probed after MLO/SPL. > > It looks like your use case implicitly depends on pinmux being > > reconfigured no matter if we are pre-relocated (MLO) or afterwards. > > > > Yes, that's a much clearer description... Frankly, your mail opened my eyes to a use case which was handled (I assume on purpose) with the old code - the "cross" boot with pinmux and devices. For example boot from UART (MLO/SPL) and then continue with eMMC (which require pinmux). > Best regards, Lukasz Majewski -- DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-59 Fax: (+49)-8142-66989-80 Email: lu...@denx.de
pgpJuoEt05lBT.pgp
Description: OpenPGP digital signature
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
