This commit prevents from re-configuring pins if those were configured
before relocation.
Some pins - like UART or DDR must be setup before relocation
(as they have 'u-boot,dm-pre-reloc' property set in DTS). Without this
change, those pins are re-configured after relocation (pre_reloc_only = 0,
so we do not "continue").
Such behavior may be a problem for DDR PAD configuration, as they might
be already leveled/tuned with original setup).
Signed-off-by: Lukasz Majewski <lu...@denx.de>
---
drivers/pinctrl/pinctrl-uclass.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-uclass.c b/drivers/pinctrl/pinctrl-uclass.c
index 6db0445067..29c910c55f 100644
--- a/drivers/pinctrl/pinctrl-uclass.c
+++ b/drivers/pinctrl/pinctrl-uclass.c
@@ -117,9 +117,9 @@ static int pinconfig_post_bind(struct udevice *dev)
int ret;
dev_for_each_subnode(node, dev) {
- if (pre_reloc_only &&
- !ofnode_pre_reloc(node))
+ if (pre_reloc_only ^ ofnode_pre_reloc(node))
continue;
+
/*
* If this node has "compatible" property, this is not
* a pin configuration node, but a normal device. skip.
--
2.11.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
