On Thu, Jan 14, 2016 at 3:03 AM, Stefan Agner <ste...@agner.ch> wrote: > On 2016-01-07 01:22, Bin Meng wrote: >> Hi Alison, >> >> On Thu, Jan 7, 2016 at 2:19 PM, Huan Wang <alison.w...@nxp.com> wrote: >>> Hi, Bin, >>> >>>> On Thu, Jan 7, 2016 at 2:01 PM, Huan Wang <alison.w...@nxp.com> wrote: >>>> > Hi, Bin, >>>> > >>>> >> On Wed, Jan 6, 2016 at 1:31 PM, Huan Wang <alison.w...@nxp.com> wrote: >>>> >> > Hi, >>>> >> > >>>> >> > I tested this set on my LS1021ATWR board. NOR boot using >>>> >> > DUART >>>> >> as serial output is ok. But NOR boot using LPUART as serial output >>>> >> failed. How about your test result? >>>> >> > >>>> >> >>>> >> Yes, I tested NOR boot using DUART or LPUART. Both boot. I suspect >>>> >> you forgot to update the RCW for LPUART, or change the jumper setting >>>> >> (J19, >>>> >> J20) to route the LPUART signal. >>>> >> >>>> > [Alison Wang] I updated the RCW for LPUART and changed the jumper >>>> > setting (J19, J20). Without this set, NOR boot using LPUART is ok. But >>>> > after adding this set, NOR boot using LPUART failed. >>>> > >>>> >>>> That's strange. Can you please send your build instructions? Did you >>>> program the u-boot-dtb.bin (not u-boot.bin anymore) to the NOR? >>>> >>> [Alison Wang] My build instructions are, >>> >>> make ARCH=arm ls1021atwr_nor_lpuart_defconfig >>> make >>> >>> Yes. I programmed u-boot-dtb.bin to NOR flash. >>> >> >> Oh, it turns out the last thing to suspect is the /chose node :) >> >> See comments in patch#8 in this series >> (http://patchwork.ozlabs.org/patch/561859/) >> >> chosen { >> + /* >> + * With ls1021atwr_nor_lpuart_defconfig configuration, >> + * this needs to be changed to &lpuart0. >> + */ >> stdout-path = &uart0; >> }; >> >> I was wondering whether I should introduce another separate dts file >> for this LPUART configuration, something like ls1021a-twr_lpuart.dts, >> but I felt it's quite some duplication thus I chose to just add some >> comments under the /chosen node in the original dts file. > > How about: > ls1021a-twr.dts => ls1021a-twr.dtsi > > And include that from > ls1021a-twr-uart.dts > ls1021a-twr-lpuart.dts > and add the /chosen node to those files. >
Yep, will take this approach in v2. Thanks! Regards, Bin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
