Hi Alison, On Thu, Jan 7, 2016 at 2:01 PM, Huan Wang <alison.w...@nxp.com> wrote: > Hi, Bin, > >> On Wed, Jan 6, 2016 at 1:31 PM, Huan Wang <alison.w...@nxp.com> wrote: >> > Hi, >> > >> > I tested this set on my LS1021ATWR board. NOR boot using DUART >> as serial output is ok. But NOR boot using LPUART as serial output >> failed. How about your test result? >> > >> >> Yes, I tested NOR boot using DUART or LPUART. Both boot. I suspect you >> forgot to update the RCW for LPUART, or change the jumper setting (J19, >> J20) to route the LPUART signal. >> > [Alison Wang] I updated the RCW for LPUART and changed the jumper setting > (J19, J20). Without this set, NOR boot using LPUART is ok. But after adding > this set, NOR boot using LPUART failed. >
That's strange. Can you please send your build instructions? Did you program the u-boot-dtb.bin (not u-boot.bin anymore) to the NOR? Regards, Bin _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
