Hi Stefano, On Tue, Mar 17, 2015 at 2:09 PM, Stefano Babic <sba...@denx.de> wrote:
> The arm library calls always print_cpuinfo(), where get_reset_cause() is > called. In this patch, print_cpuinfo() is called the second time in > board_late_init(), too. It should be dropped. > > Without testing, I think that this issue hits the mx53loco, too. Yes, you are right. The reason I called print_cpuinfo() inside board_late_init() was because I wanted to print the cpu speed after the PMIC voltage has been bumped and the clock was set to 1GHz. Without doing so I always got CPU frequency as 800MHz. At that time, I was not able to get the PMIC to setup the required voltage for 1GHz operation early enough so that print_cpuinfo shows 1GHz instead of 800MHz. Maybe this is possible now, but haven't tried it. Will only have access to mx53qsb when I am back to the office on the week of April 6th. Regards, Fabio Estevam _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
