Hi All,
I'm trying to make a custom OOT block for rfnoc4.
I already went through the synthesis of the stock rfnoc firmware, as well as
the gain example: all works well on my x300.
I added some custom logic in the gain example's verilog and I am quite
satisfied with the results.
The next step for
On 2022-08-16 18:48, Dave NotTelling wrote:
Correction, the point at which the images go away is ~ 900 MHz. Below
is a link to a video where I sweep from ~ 40 MHz up to 2.4 GHz. Note
that the images are only present in the beginning. The X310 is cabled
directly to my spec-an with no addition
Correction, the point at which the images go away is ~ 900 MHz. Below is a
link to a video where I sweep from ~ 40 MHz up to 2.4 GHz. Note that the
images are only present in the beginning. The X310 is cabled directly to
my spec-an with no additional attenuation.
https://youtu.be/jqUlK4WWvoQ
O
Marcus,
I figured out the flash issue! It was related to the power switch
issue. There are four screws that go into the top and bottom of the front
panel of the chassis. Two from the bottom, two from the top. One of the
screws in the bottom was either too long, or not supposed to be there
