Jesse,
Have had this happen.
Can be a couple things.
There are little plastic pieces inside the control box that have contacts.
These can be adjusted.
You will need to get at the control box and open it.
Wattsun can walk you through it. If not they will send you a new controller.
Same thing ca
600
>
> -Original Message-
> From: RE-wrenches [mailto:re-wrenches-boun...@lists.re-wrenches.org] On
> Behalf Of jay peltz
> Sent: Monday, September 22, 2014 10:07 AM
> To: RE-wrenches
> Subject: Re: [RE-wrenches] Watsun problem
>
> Hi Jesse
>
> I've always
I called a few months ago and talked to them about it, I checked all the things
they mentioned. The limit switch wasn't mentioned.
Jesse
Sent from my iPad
> On Sep 22, 2014, at 12:07 PM, jay peltz wrote:
>
> Hi Jesse
>
> I've always found the tech support at Array tech to be really good
> I
reinstallation.
William
Lic 773985
millersolar.com
805-438-5600
-Original Message-
From: RE-wrenches [mailto:re-wrenches-boun...@lists.re-wrenches.org] On
Behalf Of jay peltz
Sent: Monday, September 22, 2014 10:07 AM
To: RE-wrenches
Subject: Re: [RE-wrenches] Watsun problem
Hi Jesse
I've a
Sounds like you are driving it too far to the East. You may need to
rotate the tracker on the pole towards the east, and then reset the
limit switches.
Also, don't have the limits more than 180 degrees total, or you start
asking for trouble. It can try to do the morning reset back around to
t
Hi Jesse
I've always found the tech support at Array tech to be really good
I'd call them.
Jay
Peltz power
> On Sep 22, 2014, at 9:30 AM, Solar wrote:
>
> Hello,
>
> I am having an issue with a Watsun dual axis tracker. It is a 24VDC model,
> run of a battery bank that is charged throug
A small amount of dirt or (more probably, bird crap on the E sensor might do
that. Also, try moving the limit switch to limit the E stop by just a tooth or
two. If that works, it's probably because there is a bit of wear on the gearing
which would be normal.
Bob-O
On Sep 22, 2014, at 5:27 PM, S
Thanks for the reply.
I didn't see any spots in the control box that make me question it. I will say
that when it was installed the circuit board had to be sent back because a few
of the solder spots on the back of the circuit board were not smoothed out and
then had pierced wires causing the
Any sign of electronics failure in the controller box?
Recent lightning activity in close proximity?
How about a dead spot in the limit switch, or limit switch inoperable?
-Original Message-
From: "Solar"
Sent: 9/22/2014 12:30
To: "Wrenches"
Subject: [RE-wrenches] Watsun problem
Hell
9 matches
Mail list logo
