Can you point to a reference to what stage 0 is?  This is a new term for me. So far, have not installed multiple Sol-Ark inverters at one site.  Thank you, Chris

On 11/12/2024 12:50 PM, Poole, Jharen via RE-wrenches wrote:
Our inverters utilize CANbus communications for establishing parallel operation between multiple Sol-Ark inverters. CANbus communication operates as a serial communication protocol. In this setup each inverter in the setup is linked via a parallel communication cable forming a daisy-chain configuration. If one inverter in the chain experiences a shutdown due to a fault, the communication chain is disrupted. Consequently, the other inverters will also power down when we see this loss, ensuring system protection and safeguarding the customer’s investment.

Paralleling must be done at a stage 0 they have to sync and that is done in the pre normal mode, functionality wise having them going into sync is extremely difficult due to timing issues. It's easier to time it from a stage 0 than to do it when one unit is already running.

Maintaining synchronization between inverters is critical; if the inverters were to operate out of parallel it can result in conflicts between the operation of inverters and desynchronization of the units. This misalignment can escalate, potentially causing significant damage to one or more inverters and risking harm to other connected equipment.


Best Regards,

Jharen Poole
Applications Engineer II
972-575-8875

_______________________________________________
List sponsored by Redwood Alliance

Pay optional member dues here:http://re-wrenches.org

List Address:RE-wrenches@lists.re-wrenches.org

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

There are two list archives for searching. When one doesn't work, try the other:
https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org

List rules & etiquette:
http://www.re-wrenches.org/etiquette.htm

Check out or update participant bios:
http://www.members.re-wrenches.org

--
Christopher Warfel, PE
Entech Engineering, Inc.
POB 871 Block Island, RI 02807
401-447-5773
_______________________________________________
List sponsored by Redwood Alliance

Pay optional member dues here: http://re-wrenches.org

List Address: RE-wrenches@lists.re-wrenches.org

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

There are two list archives for searching. When one doesn't work, try the other:
https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org

List rules & etiquette:
http://www.re-wrenches.org/etiquette.htm

Check out or update participant bios:
http://www.members.re-wrenches.org

Reply via email to