I think the term is "broaching" (not to be confused with the machining 
process).  We use a lot of PEM nuts  (http://www.pemnet.com) in our enclosures 
in which a press is used to force a fastener into a piece of sheet-metal.  
Swaging is more akin to riveting.  Swaging can be done with a hammer and punch.





________________________________
 From: TyngTech <[email protected]>
To: [email protected] 
Sent: Monday, February 18, 2013 1:47 PM
Subject: [TANKS] Re: Tyng T-Max Suspension Photos
 

Fred wrote:

"I notice, in T-Max3.jpg, that the bolt that holds the swing arm plate to the 
square 
tube doesn't seem to have a weld on it; is this to allow for micro adjustments 
to 
the swing arm plate's position and is it enough to hold it in place"

Correct, there is no weld.  As you state, I can adjust the angle of the arm to 
the square piece and thus adjust ride height.

In the following pic, you can see where I filed away a small bit if steel 
between the corners of the steel tube to form teeth.  When I
finalize the suspension positioning, the assembly's get "set" into position by 
hammering and torquing down on the bolt.  This digs
the teeth into the aluminum swingarm and locks them in place.  According to Joe 
Sommer this is called swaging.


" As shown in T-Max3 and more vividly in T-Max2, the nylon bushing at the 
internal end 
of the swing assembly seems to function as your bearing (neat Idea) but if you 
had 
narrowed your wood pieces, added a second locknut spaced 1/8th away from the 
"lock nut", 
allowed the "excess" thread on the bolt to pass thru a metal plate then secured 
with 
another nut, snug but still allowing the swing assembly to pivot, would this 
prevent 
the swing arm assembly from popping out in the event the the rubber friction 
fit, 
after a bit of wear sets in, isn't sufficient to hold it?"

This was a thought of mine also.  In full size torsion axles used in road 
trailers, there is typically no support
beyond the compressed rubber to hold the axles in place.  I'd thought I'd try 
it this way first for simplicity
sake.  If I find the axles wandering, I'll replace the bushings with thinner 
ones that lock to the hull and
place a bolt as you suggest.

Steve Tyng
-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat
 
--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.

-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.


Reply via email to