Hi Steve,

 An awesome design. I tip my hat to you.

 I notice, in T-Max3.jpg, that the bolt that holds the swing arm plate
to the square
tube doesn't seem to have a weld on it; is this to allow for micro
adjustments to
the swing arm plate's position and is it enough to hold it in place?
 As shown in T-Max3 and more vividly in T-Max2, the nylon bushing at
the internal end
of the swing assembly seems to function as your bearing (neat Idea)
but if you had
narrowed your wood pieces, added a second locknut spaced 1/8th away
from the "lock nut",
allowed the "excess" thread on the bolt to pass thru a metal plate
then secured with
another nut, snug but still allowing the swing assembly to pivot,
would this prevent
the swing arm assembly from popping out in the event the the rubber
friction fit,
after a bit of wear sets in, isn't sufficient to hold it?

Cheers,
Fred "over engineering isn't a good idea, it's the law" Thomson


[...or maybe my middle name should be: "Stug III, thy name is
Retrofit." ]

-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.


Reply via email to