On Thu, 19 Jun 2008 20:26:01 +0900, Salvatore Toribio <[EMAIL PROTECTED]> wrote:
> Well, you have give me a hint.. I was using qs-2.02st, SA-3.2.4 and I > haven't seen the issue but I didn't pay atention to it before the > release of 2.04. [clip] > Maybe you can install 2.02st and enabled 'sa_alt' I reverted back to qs-2.02 a few days ago, and so far all mails are coming in with the Message-ID in the header intact. So the problem is indeed with qmail-scanner, and not SpamAssassin. I haven't been using the st patches at all, with either 2.04 or 2.02, so the problem is with the original code. I did a diff between the generated qs2.02 and qs2.04, and most of the changes involved the Clam scanner. I've never been very good with perl, so it's a bit difficult for me to understand what's going on. I will try a step up to 2.03 over the next few days and see if I can isolate exactly where the problem code is. -- - breakpoint / brainstorm ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Qmail-scanner-general mailing list Qmail-scanner-general@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/qmail-scanner-general
