The boot loader on these boards is routerboot. I do not know if routerboot provides a md like command or not.
Sent from my iPhone > On Dec 13, 2014, at 1:01 AM, John Crispin <blo...@openwrt.org> wrote: > > Hi, > >> On 10/12/2014 22:33, Chris Green wrote: >>> On Wed, Dec 10, 2014 at 01:40:42PM -0700, Davey Hutchison wrote: >>> Fix pll_1000 value for eth0. Traffic would not flow from the eth0 >>> interface. >>> The new PLL enables delay, use ath79_setup_ar934x_eth_cfg to also enable >>> AR934X_ETH_CFG_RXD_DELAY. >>> >>> Signed-off-by: Davey Hutchison <dhutchi...@bluemesh.net> >>> >>> --- target/linux/ar71xx/files/arch/mips/ath79/mach-rb95x.c >>> +++ target/linux/ar71xx/files/arch/mips/ath79/mach-rb95x.c >>> @@ -199,6 +199,7 @@ >>> return; >>> >>> ath79_setup_ar934x_eth_cfg(AR934X_ETH_CFG_RGMII_GMAC0 | >>> + AR934X_ETH_CFG_RXD_DELAY | >>> AR934X_ETH_CFG_SW_ONLY_MODE); >>> >>> ath79_register_mdio(0, 0x0); >>> @@ -209,6 +210,7 @@ >>> ath79_init_mac(ath79_eth0_data.mac_addr, ath79_mac_base, 0); >>> ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII; >>> ath79_eth0_data.phy_mask = BIT(0); >>> + ath79_eth0_pll_data.pll_1000 = 0x3e000000; >>> >>> ath79_register_eth(0); >> >> This needs to be in mach-rb2011.c as well. > > > i will hopefully get round to looking at this today. first i could not > find my rs232 usb keyspan thingy, then i failed to find the poe injector .. > > do these board have uboot ? if so the easiest way would be to enter > uboot, start a tftp to make sure the network is configured and then use > the md command to display the relevant register. > > John > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
