Hi,
On 10/12/2014 22:33, Chris Green wrote:
> On Wed, Dec 10, 2014 at 01:40:42PM -0700, Davey Hutchison wrote:
>> Fix pll_1000 value for eth0. Traffic would not flow from the eth0 interface.
>> The new PLL enables delay, use ath79_setup_ar934x_eth_cfg to also enable
>> AR934X_ETH_CFG_RXD_DELAY.
>>
>> Signed-off-by: Davey Hutchison <dhutchi...@bluemesh.net>
>>
>> --- target/linux/ar71xx/files/arch/mips/ath79/mach-rb95x.c
>> +++ target/linux/ar71xx/files/arch/mips/ath79/mach-rb95x.c
>> @@ -199,6 +199,7 @@
>> return;
>>
>> ath79_setup_ar934x_eth_cfg(AR934X_ETH_CFG_RGMII_GMAC0 |
>> + AR934X_ETH_CFG_RXD_DELAY |
>> AR934X_ETH_CFG_SW_ONLY_MODE);
>>
>> ath79_register_mdio(0, 0x0);
>> @@ -209,6 +210,7 @@
>> ath79_init_mac(ath79_eth0_data.mac_addr, ath79_mac_base, 0);
>> ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
>> ath79_eth0_data.phy_mask = BIT(0);
>> + ath79_eth0_pll_data.pll_1000 = 0x3e000000;
>>
>> ath79_register_eth(0);
>
> This needs to be in mach-rb2011.c as well.
>
i will hopefully get round to looking at this today. first i could not
find my rs232 usb keyspan thingy, then i failed to find the poe injector ..
do these board have uboot ? if so the easiest way would be to enter
uboot, start a tftp to make sure the network is configured and then use
the md command to display the relevant register.
John
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
