Hallo
Florin Andrei wrote: > Bernhard Praschinger wrote: >> How did you get that Average/Peak bit-rate output from mpeg2enc ? > Not directly from mpeg2enc, but at a later stage, with mplex. > Here are the values for -q 8: > > INFO: [mplex] Average bit-rate : 4421600 bits/sec > INFO: [mplex] Peak bit-rate : 7118400 bits/sec > INFO: [mplex] Average bit-rate : 3231600 bits/sec > INFO: [mplex] Peak bit-rate : 7464400 bits/sec Sorry for being unclear in my last mail. But how do you generate that output when you mplex the movie and which mplex command do you use ? (So I can do the same on my machine) > These seem a bit low for encoding with -b 8000, isn't it? I should > probably go back to -q 7, where it hits 9200 max on one file, and it's > otherwise around 8000, plus or minus a few hundred, on all other files. Depends on the output of mpeg2enc. When you see always lines like that: Enc1 24 26(11) P q=8.00 And no higher numbers, it would be ok for me. auf hoffentlich bald, Berni the Chaos of Woodquarter Email: [EMAIL PROTECTED] www: http://www.lysator.liu.se/~gz/bernhard ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Mjpeg-users mailing list Mjpeg-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/mjpeg-users
