Hello,
I just tried Linux 2.6.25-rc6 on my TQM5200 module and got the attached
oops. Are there any known patches fixing the problems?
TIA.
Wolfgang.
## Booting image at 00200000 ...
Image Name: Linux-2.6.25-rc6-01058-gf8937ce-
Created: 2008-03-20 13:19:36 UTC
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 1697503 Bytes = 1.6 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Booting using the fdt at 0x400000
[ 0.000000] Using mpc5200-simple-platform machine description
[ 0.000000] Linux version 2.6.25-rc6-01058-gf8937ce-dirty ([EMAIL PROTECTED]) (gcc version 4.0.0 (DENX ELDK 4.1 4.0.0)) #14 Thu Mar 20 14:19:25 CET 2008
[ 0.000000] PCI host bridge /[EMAIL PROTECTED] (primary) ranges:
[ 0.000000] MEM 0x0000000080000000..0x000000008fffffff -> 0x0000000080000000 Prefetch
[ 0.000000] MEM 0x0000000090000000..0x000000009fffffff -> 0x0000000090000000
[ 0.000000] IO 0x00000000a0000000..0x00000000a0ffffff -> 0x0000000000000000
[ 0.000000] Zone PFN ranges:
[ 0.000000] DMA 0 -> 16384
[ 0.000000] Normal 16384 -> 16384
[ 0.000000] Movable zone start PFN for each node
[ 0.000000] early_node_map[1] active PFN ranges
[ 0.000000] 0: 0 -> 16384
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
[ 0.000000] Kernel command line: root=/dev/nfs rw nfsroot=10.0.30.2:/opt/eldk/ppc_6xx ip=10.0.30.210:10.0.30.2:::tqm5200:eth0:off panic=1 console=ttyPSC0,115200
[ 0.000000] MPC52xx PIC is up and running!
[ 0.000000] PID hash table entries: 256 (order: 8, 1024 bytes)
[ 0.000014] clocksource: timebase mult[79364d9] shift[22] registered
[ 0.000241] console [ttyPSC0] enabled
[ 0.004376] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.008573] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.021186] Memory: 61236k/65536k available (3328k kernel code, 4236k reserved, 120k data, 149k bss, 180k init)
[ 0.024179] SLUB: Genslabs=12, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1
[ 0.120160] Mount-cache hash table entries: 512
[ 0.128111] net_namespace: 152 bytes
[ 0.133162] NET: Registered protocol family 16
[ 0.150957] PCI: Probing PCI hardware
[ 0.168836] SCSI subsystem initialized
[ 0.174379] usbcore: registered new interface driver usbfs
[ 0.176629] usbcore: registered new interface driver hub
[ 0.180942] usbcore: registered new device driver usb
[ 0.200000] Time: timebase clocksource has been installed.
[ 0.208268] NET: Registered protocol family 2
[ 0.252350] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.260660] TCP established hash table entries: 2048 (order: 2, 16384 bytes)
[ 0.268181] TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.272125] TCP: Hash tables configured (established 2048 bind 2048)
[ 0.276028] TCP reno registered
[ 0.338145] JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
[ 0.342627] io scheduler noop registered
[ 0.344114] io scheduler anticipatory registered (default)
[ 0.348032] io scheduler deadline registered
[ 0.352847] io scheduler cfq registered
[ 0.778513] Generic RTC Driver v1.07
[ 0.780658] Serial: MPC52xx PSC UART driver
[ 0.784474] f0002000.serial: ttyPSC0 at MMIO 0xf0002000 (irq = 129) is a MPC52xx PSC
[ 0.793028] f0002200.serial: ttyPSC1 at MMIO 0xf0002200 (irq = 130) is a MPC52xx PSC
[ 0.797297] f0002400.serial: ttyPSC2 at MMIO 0xf0002400 (irq = 131) is a MPC52xx PSC
[ 0.814501] brd: module loaded
[ 0.823106] loop: module loaded
[ 0.824132] vcan: Virtual CAN interface driver
[ 0.828033] slcan: serial line CAN interface driver
[ 0.832030] slcan: 10 dynamic interface channels.
[ 0.840408] mpc52xx-mscan mpc52xx-mscan.0: probe for port at 0xC5062900 done (irq 145)
[ 0.846001] mpc52xx-mscan mpc52xx-mscan.1: probe for port at 0xC5064980 done (irq 146)
[ 0.852251] Unable to handle kernel paging request for data at address 0x0000000c
[ 0.860026] Faulting instruction address: 0xc0017fec
[ 0.864036] Oops: Kernel access of bad area, sig: 11 [#1]
[ 0.868000] mpc5200-simple-platform
[ 0.868000] Modules linked in:
[ 0.868000] NIP: c0017fec LR: c0019064 CTR: 00000010
[ 0.868000] REGS: c381fd20 TRAP: 0300 Not tainted (2.6.25-rc6-01058-gf8937ce-dirty)
[ 0.868000] MSR: 00009032 <EE,ME,IR,DR> CR: 28000028 XER: 2000005f
[ 0.868000] DAR: 0000000c, DSISR: 20000000
[ 0.868000] TASK = c3812400[1] 'swapper' THREAD: c381e000
[ 0.868000] GPR00: 00000010 c381fdd0 c3812400 00000100 00000008 00000008 fcff7000 c382ca00
[ 0.868000] GPR08: 00002000 00000000 00000000 f00035a9 f0003000 fefd7f7f 07fb3000 04000000
[ 0.868000] GPR16: 00000000 007fff00 00000000 c02c0000 c0340000 c0330000 07fb2678 00000000
[ 0.868000] GPR24: c0330000 00000008 c0360000 00000100 00000008 f0003184 000005f2 00000000
[ 0.868000] NIP [c0017fec] bcom_task_alloc+0x30/0x198
[ 0.868000] LR [c0019064] bcom_fec_rx_init+0x24/0x74
[ 0.868000] Call Trace:
[ 0.868000] [c381fdd0] [c006863c] __get_vm_area_node+0x80/0x1b8 (unreliable)
[ 0.868000] [c381fe00] [c0019064] bcom_fec_rx_init+0x24/0x74
[ 0.868000] [c381fe20] [c028428c] 0xc028428c
[ 0.868000] [c381fe60] [c01ea26c] of_platform_device_probe+0x58/0x80
[ 0.868000] [c381fe80] [c017ddd0] driver_probe_device+0xb8/0x1cc
[ 0.868000] [c381fea0] [c017e0bc] __driver_attach+0xcc/0xf8
[ 0.868000] [c381fec0] [c017c93c] bus_for_each_dev+0x58/0x94
[ 0.868000] [c381fef0] [c017db00] driver_attach+0x24/0x34
[ 0.868000] [c381ff00] [c017d9c0] bus_add_driver+0x188/0x250
[ 0.868000] [c381ff20] [c017e598] driver_register+0x48/0x130
[ 0.868000] [c381ff40] [c01ea48c] of_register_driver+0x54/0x70
[ 0.868000] [c381ff50] [c032c6b4] mpc52xx_fec_init+0x64/0x80
[ 0.868000] [c381ff70] [c0313858] kernel_init+0x98/0x28c
[ 0.868000] [c381fff0] [c001229c] kernel_thread+0x44/0x60
[ 0.868000] Instruction dump:
[ 0.868000] 7c0802a6 9421ffd0 bf210014 3f40c036 7c7b1b78 7c992378 90010034 38000010
[ 0.868000] 7cbc2b78 813a5224 7c0903a6 3be00000 <8129000c> 80090004 57fd2834 2f800000
[ 0.868081] ---[ end trace ab0c326e02602f58 ]---
[ 0.872036] Kernel panic - not syncing: Attempted to kill init!
[ 0.876034] Rebooting in 1 seconds..
U-Boot 1.3.1-g5f7f945a-dirty (Dec 19 2007 - 16:58:01)
CPU: MPC5200B v2.2, Core v1.4 at 396 MHz
Bus 132 MHz, IPB 132 MHz, PCI 66 MHz
Board: TQM5200 (TQ-Components GmbH)
on a STK52xx carrier board
I2C: 85 kHz, ready
DRAM: 128 MB
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
