[PATCH 3/5] arm64: dts: imx8mq-phanbell: Replace deprecated phy reset properties

[Krzysztof Kozlowski]

Use preferred properties of phy node instead of deprecated
phy-reset-gpios (and others).  This avoids copying deprecated code into
future DTSes.

Signed-off-by: Krzysztof Kozlowski <k...@kernel.org>

---

Not tested on HW.
---
 arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts 
b/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
index 77ab568fae67..3f541ddf0768 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mq-phanbell.dts
@@ -262,9 +262,6 @@
        pinctrl-names = "default";
        pinctrl-0 = <&pinctrl_fec1>;
        phy-mode = "rgmii-id";
-       phy-reset-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
-       phy-reset-duration = <10>;
-       phy-reset-post-delay = <50>;
        phy-handle = <&ethphy0>;
        fsl,magic-packet;
        status = "okay";
@@ -275,6 +272,9 @@
                ethphy0: ethernet-phy@0 {
                        compatible = "ethernet-phy-ieee802.3-c22";
                        reg = <0>;
+                       reset-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
+                       reset-assert-us = <10000>;
+                       reset-deassert-us = <50000>;
                };
        };
 };
-- 
2.17.1