OK; the next stage...
We use a 'ringmaster' number and a distinctive ring cadence
detector to send fax calls to the fax. It's upstream of
trunk 2 entering the KXTA.
BUT, the KXTA picks up that line BEFORE the detector decides.
So options are:
a) Delay TVA50 pickup of that line until detector has had its shot.
Doing so on trunk 2 only was a minor plus; it's a 2-body office
and outside human could tell inside human was on the phone since
VM didn't pick up on first ring. They'd hang up iffen they wanted
the person not her VM.
b) Give up on ringbastard [It's like $8.00 a month here in Verizontaland]
and depend on Panasonic's CNG detection.
What's the list's advice?
To do b) I must force fax to use ONLY trunk 2. [why? below] I know
where such a table for outgoing CO vs Stations was on KXTD-1232;
can I assume there's one on the KXTA as well? {I am not in front of
the system as I write this; & the Fine Manuals are there as well..}
(With the fax on a KXTA station port; I want it to dial out on
the same trunk listed as the "fax number" -- that way, calling
fax machines should NOT skunked by the AA answering & finding
the fax station busy.)
--
A host is a host from coast to [EMAIL PROTECTED]
& no one will talk to a host that's close........[v].(301) 56-LINUX
Unless the host (that isn't close).........................pob 1433
is busy, hung or dead....................................20915-1433
_________________________________________________________________
KX-T Mailing list --- http://kxthelp.com/
Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
