Support wrote: > While programming, that position 1 is the lower position and also I > have tried all the alternative to see whether it works or not. But > none work. I have also removed the cable and back in again. It is > still not working. > I wonder how I can be able to test it should be working or not. > Is there any symptons or something which I can check the card is ok or > not? > > Thanks in advance. > > > > > > ----- Original Message ----- From: "Erling Lassesen" <[EMAIL PROTECTED]> > To: "'Support'" <[EMAIL PROTECTED]>; "'Shawn Ceanga'" > <[EMAIL PROTECTED]> > Cc: <kxt@kxthelp.com> > Sent: Tuesday, September 13, 2005 8:15 PM > Subject: RE: KX-T: First time 16SLC (KX-TD174DX) Card installation on > KX-TD1232 > > >> Did you remember when programming that Position 1 is the lower position? >> Also, did you try re-inserting the ribbon cable connector? >> >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On >> Behalf Of >> Support >> Sent: Tuesday, September 13, 2005 12:44 AM >> To: Shawn Ceanga >> Cc: kxt@kxthelp.com >> Subject: Re: KX-T: First time 16SLC (KX-TD174DX) Card installation on >> KX-TD1232 >> >> I have rebooted the system after the unit is installed. >> And also rebooted again after the programming. >> However, I still cannot hear the dail tone. >> >> >> >> >> ----- Original Message ----- From: "Shawn Ceanga" >> <[EMAIL PROTECTED]> >> To: "Support" <[EMAIL PROTECTED]> >> Cc: <kxt@kxthelp.com> >> Sent: Monday, September 12, 2005 3:37 PM >> Subject: Re: KX-T: First time 16SLC (KX-TD174DX) Card installation on >> KX-TD1232 >> >> >>> Support wrote: >>> >>>> Hi, >>>> >>>> This is my first time installing the expension modules on 1232 pbx. >>>> I'm installing 16SLC Card (KX-TD174DX) and KX-TD1232 PBX. >>>> I have installed it in the expension area 1 and put the internal screw >>>> already. >>>> I programmed using #109 with A1,E2,C set. >>>> However, I cannot be able to hear the dial tone when I attach a single >>>> line telephone to the jack. >>>> It has 8 Jacks on the board with 4 pins each. I tried to connect the >>>> single line telephone on pin 1,2, but it didn't work. >>>> So I tried to connect the single line telephone on pin 2,3 and >>>> still it is >>> >> >>>> not working. >>>> I tried on pin 1,4 as well but it didn't work either. >>>> So, I think I'm missing on the cable assignments or am I missing on >>>> the >>>> programming feature? >>>> Your helps would be greatly appreciated. >>>> >>>> Arnold. >>>> _________________________________________________________________ >>>> KX-T Mailing list --- http://kxthelp.com/ >>>> Subscription changes: http://kxthelp.com/mailman/listinfo/kxt >>>> >>>> >>>> >>> did you reboot the system?are you sure its in slot 1 ? >>> >>> >> >> >> _________________________________________________________________ >> KX-T Mailing list --- http://kxthelp.com/ >> Subscription changes: http://kxthelp.com/mailman/listinfo/kxt >> >> >> >> > > > yes there is diagnostic tests that can be done do you have the blue dos for the 1232?
_________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
