While programming, that position 1 is the lower position and also I have tried all the alternative to see whether it works or not. But none work. I have also removed the cable and back in again. It is still not working. I wonder how I can be able to test it should be working or not. Is there any symptons or something which I can check the card is ok or not?
Thanks in advance. ----- Original Message ----- From: "Erling Lassesen" <[EMAIL PROTECTED]> To: "'Support'" <[EMAIL PROTECTED]>; "'Shawn Ceanga'" <[EMAIL PROTECTED]> Cc: <kxt@kxthelp.com> Sent: Tuesday, September 13, 2005 8:15 PM Subject: RE: KX-T: First time 16SLC (KX-TD174DX) Card installation on KX-TD1232 > Did you remember when programming that Position 1 is the lower position? > Also, did you try re-inserting the ribbon cable connector? > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf > Of > Support > Sent: Tuesday, September 13, 2005 12:44 AM > To: Shawn Ceanga > Cc: kxt@kxthelp.com > Subject: Re: KX-T: First time 16SLC (KX-TD174DX) Card installation on > KX-TD1232 > > I have rebooted the system after the unit is installed. > And also rebooted again after the programming. > However, I still cannot hear the dail tone. > > > > > ----- Original Message ----- > From: "Shawn Ceanga" <[EMAIL PROTECTED]> > To: "Support" <[EMAIL PROTECTED]> > Cc: <kxt@kxthelp.com> > Sent: Monday, September 12, 2005 3:37 PM > Subject: Re: KX-T: First time 16SLC (KX-TD174DX) Card installation on > KX-TD1232 > > >> Support wrote: >> >>>Hi, >>> >>>This is my first time installing the expension modules on 1232 pbx. >>>I'm installing 16SLC Card (KX-TD174DX) and KX-TD1232 PBX. >>>I have installed it in the expension area 1 and put the internal screw >>>already. >>>I programmed using #109 with A1,E2,C set. >>>However, I cannot be able to hear the dial tone when I attach a single >>>line telephone to the jack. >>>It has 8 Jacks on the board with 4 pins each. I tried to connect the >>>single line telephone on pin 1,2, but it didn't work. >>>So I tried to connect the single line telephone on pin 2,3 and still it >>>is > >>>not working. >>>I tried on pin 1,4 as well but it didn't work either. >>>So, I think I'm missing on the cable assignments or am I missing on the >>>programming feature? >>>Your helps would be greatly appreciated. >>> >>>Arnold. >>>_________________________________________________________________ >>>KX-T Mailing list --- http://kxthelp.com/ >>>Subscription changes: http://kxthelp.com/mailman/listinfo/kxt >>> >>> >>> >> did you reboot the system?are you sure its in slot 1 ? >> >> > > > _________________________________________________________________ > KX-T Mailing list --- http://kxthelp.com/ > Subscription changes: http://kxthelp.com/mailman/listinfo/kxt > > > > _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
