I use Bogen amps - page 1 for inside, page 2 for outside. I believe ICM 330 is for page 1, ICM 331 is for outside; I know ICM 33* is for both. Try ICM 33* - that works the best here, 330 is low for some reason. I used shielded cable with the center conductor to tip, shield to ring at the amp.
My system is a -4, and also shows 196 as not valid, although I don't know where you got that. Good luck, -- Larry Email to rapp at lmr dot com On Fri, 15 Apr 2005 15:54:29 -0400, you wrote (with possible editing): >I just connected a Valcom 1030C horn speaker to paging port 1 on a KX-TD >1232-6. I cannot get this to work. > >I am using icm 330 to try and page via the new speaker. Is this >correct? In the programming, under Musinc and Paging, it shows External >Paging 1 as Ext 196. If I try using Ext 196, I get "Invalid" >response. Does the 1232 need to be restarted when connecting a new paging >device? > >The Valcom 1030C has a built in amp and volume control. I have the volume >there set at about 1/2 or slightly higher. The cable run for the power >supply is only about 20 ft. The run for the connection to the 1232 is >about 120 feet or so. This speaker was purchased used but according to >owner, it was working when removed from warehouse. I had to purchase the >power supply for it. > >Mike Wasilewski >Five Star Services, Inc. >Tele 770-924-9156 >Fax 770-516-8393 > > >_________________________________________________________________ >KX-T Mailing list --- http://kxthelp.com/ >Subscription changes: http://kxthelp.com/mailman/listinfo/kxt _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
